PROBLEM SYMPTOMS TABLE
Troubleshooting · Vehicles built from Jul 2012
Versions by build date: May 2007 – Jul 2008 Aug 2008 – Jun 2010 Jul 2010 – Jun 2012 from Jul 2012
Use the table below to help determine the cause of a problem. The likely causes of the problem are indicated in descending order. Check each suspected area in order. Repair or replace faulty parts or perform adjustments as necessary.
(*1): for 4WD
- NOTICE:
- When replacing any of the brake actuator assembly or sensors, etc., turn the ignition switch off.
- HINT:
- Inspect the fuses and relays before investigating the suspected areas shown in the table below.
- Inspect each suspected area in order for the corresponding symptom.
- Inspect the fuses and relays before investigating the suspected areas shown in the table below.
| Symptom |
Suspected Area |
See page |
| ABS, BA and/or EBD does not operate |
Check for DTCs again and make sure that the normal system code is output. |
Click here
|
| IG power source circuit (Low power supply voltage malfunction) |
Click here
|
|
| IG power source circuit (High power supply voltage malfunction) |
Click here
|
|
| Front speed sensor circuit (Output malfunction) |
Click here
|
|
| Rear speed sensor circuit (Output malfunction) |
Click here
|
|
| Front speed sensor circuit (Open or short malfunction) |
Click here
|
|
| Rear speed sensor circuit (Open or short malfunction) |
Click here
|
|
| Front speed sensor circuit (Comparison malfunction) |
Click here
|
|
| Rear speed sensor circuit (Comparison malfunction) |
Click here
|
|
| Check the brake actuator assembly with the intelligent tester. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. |
Click here
|
|
| If the symptom still occurs even after the circuits listed above have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). |
Click here
|
|
| ABS, BA and/or EBD does not operate efficiently |
Check for DTCs again and make sure that the normal system code is output. |
Click here
|
| Front speed sensor circuit (Output malfunction) |
Click here
|
|
| Rear speed sensor circuit (Output malfunction) |
Click here
|
|
| Front speed sensor circuit (Open or short malfunction) |
Click here
|
|
| Rear speed sensor circuit (Open or short malfunction) |
Click here
|
|
| Front speed sensor circuit (Comparison malfunction) |
Click here
|
|
| Rear speed sensor circuit (Comparison malfunction) |
Click here
|
|
| Stop light switch circuit (Open or short malfunction) |
Click here
|
|
| Stop light switch circuit (Off stuck malfunction) |
Click here
|
|
| Check the brake actuator assembly with the intelligent tester. (Check brake actuator assembly operation using the Active Test function.) If abnormal, check the hydraulic circuit for leaks. |
Click here
|
|
| If the symptom still occurs even after the circuits listed above have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). |
Click here
|
|
| ABS sensor DTC check cannot be done |
Check for DTCs again and make sure that the normal system code is output. |
Click here
|
| TC and CG terminal circuit |
Click here
|
|
| If the symptom still occurs even after the circuits listed above have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). |
Click here
|
|
| ABS warning light abnormal (Remains on) |
ABS warning light circuit |
Click here
|
| Brake actuator assembly (Skid control ECU) |
Click here
|
|
| ABS warning light abnormal (Does not come on) |
ABS warning light circuit |
Click here
|
| Brake actuator assembly (Skid control ECU) |
Click here
|
|
| Brake warning light abnormal (Remains on) |
Brake warning light circuit |
Click here
|
| Brake actuator assembly (Skid control ECU) |
Click here
|
|
| Brake warning light abnormal (Does not come on) |
Brake warning light circuit |
Click here
|
| Brake actuator assembly (Skid control ECU) |
Click here
|
|
| VSC and/or TRC does not operate |
Check for DTCs again and make sure that the normal system code is output. |
Click here
|
| IG power source circuit (Low power supply voltage malfunction) |
Click here
|
|
| IG power source circuit (High power supply voltage malfunction) |
Click here
|
|
| Check the hydraulic circuit for leaks. |
- |
|
| Front speed sensor circuit (Output malfunction) |
Click here
|
|
| Rear speed sensor circuit (Output malfunction) |
Click here
|
|
| Front speed sensor circuit (Open or short malfunction) |
Click here
|
|
| Rear speed sensor circuit (Open or short malfunction) |
Click here
|
|
| Front speed sensor circuit (Comparison malfunction) |
Click here
|
|
| Rear speed sensor circuit (Comparison malfunction) |
Click here
|
|
| Yaw rate and acceleration sensor circuit (Zero point malfunction) |
Click here
|
|
| Yaw rate and acceleration sensor circuit (Power supply malfunction) |
Click here
|
|
| Acceleration sensor circuit (Comparison malfunction) |
Click here
|
|
| Yaw rate sensor circuit (Comparison malfunction) |
Click here
|
|
| Yaw rate and acceleration sensor circuit (Stuck or output malfunction) |
Click here
|
|
| Yaw rate and acceleration sensor circuit (Continuous invalidation malfunction) |
Click here
|
|
| Yaw rate and acceleration sensor circuit (Internal malfunction) |
Click here
|
|
| Steering angle sensor circuit (Zero point malfunction) |
Click here
|
|
| Steering angle sensor circuit (Zero point initialization or calibration malfunction) |
Click here
|
|
| Steering angle sensor circuit (Power supply malfunction) |
Click here
|
|
| Steering angle sensor circuit (Output malfunction) |
Click here
|
|
| Steering angle sensor circuit (Internal malfunction) |
Click here
|
|
| If the symptom still occurs even after the circuits listed above have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). |
Click here
|
|
| VSC sensor DTC check cannot be done |
Check for DTCs again and make sure that the normal system code is output. |
Click here
|
| TC and CG terminal circuit |
Click here
|
|
| If the symptom still occurs even after the circuits listed above have been inspected and proved to be normal, replace the brake actuator assembly (skid control ECU). |
Click here
|
|
| VSC OFF indicator light abnormal (Remains on) |
VSC OFF indicator light circuit |
Click here
|
| Brake actuator assembly (Skid control ECU) |
Click here
|
|
| VSC OFF indicator light abnormal (Does not come on) |
VSC OFF indicator light circuit |
Click here
|
| Brake actuator assembly (Skid control ECU) |
Click here
|
|
| TRC OFF indicator light abnormal (Remains on) |
TRC OFF indicator light circuit |
Click here
|
| Brake actuator assembly (Skid control ECU) |
Click here
|
|
| TRC OFF indicator light abnormal (Does not come on) |
TRC OFF indicator light circuit |
Click here
|
| Brake actuator assembly (Skid control ECU) |
Click here
|
|
| Slip indicator light abnormal (Remains on) |
Slip indicator light circuit |
Click here
|
| Brake actuator assembly (Skid control ECU) |
Click here
|
|
| Slip indicator light abnormal (Does not come on) |
Slip indicator light circuit |
Click here
|
| Brake actuator assembly (Skid control ECU) |
Click here
|
|
| Downhill assist control indicator light abnormal (Remains on) (*1) |
Downhill assist control switch circuit |
Click here
|
| Downhill assist control indicator light circuit |
Click here
|
|
| Brake actuator assembly (Skid control ECU) |
Click here
|
|
| Downhill assist control indicator light abnormal (Does not come on) (*1) |
Downhill assist control switch circuit |
Click here
|
| Downhill assist control indicator light circuit |
Click here
|
|
| Brake actuator assembly (Skid control ECU) |
Click here
|
|
| Sensor check cannot be done |
TS and CG terminal circuit |
Click here
|
| Brake actuator assembly (Skid control ECU) |
Click here
|
|
| Meter buzzer abnormal |
Meter buzzer circuit |
Click here
|
| Brake actuator assembly (Skid control ECU) |
Click here
|