DTC C1241 Low Power Supply Voltage Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1241 | Any of the following is detected:
|
|

| 1.INSPECT ECU-IG NO. 2 FUSE |
![]() |
Remove the ECU-IG NO. 2 fuse from the main body ECU (instrument panel junction block).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| ECU-IG NO. 2 (7.5 A) fuse | Always | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK BATTERY |
Install the ECU-IG NO. 2 fuse.
Check the battery voltage.
|
| ||||
| OK | |
| 3.INSPECT SKID CONTROL ECU (IG1 TERMINAL) |
![]() |
Make sure that there is no looseness at the locking part and the connecting part of the connectors.
Disconnect the skid control ECU connector.
Turn the ignition switch on (IG).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A24-34 (IG1) - Body ground | Ignition switch on (IG) | 11 to 14 V |
|
| ||||
| OK | |
| 4.INSPECT SKID CONTROL ECU (GND1 TERMINAL) |
![]() |
Turn the ignition switch off.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A24-1 (GND1) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 5.RECONFIRM DTC |
Reconnect the skid control ECU connector.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle at a speed of 20 km/h (12 mph) or more for 30 seconds or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC (C1241) is not output | A |
| DTC (C1241) is output | B |
|
| ||||
| A | ||
| ||