VEHICLE STABILITY CONTROL SYSTEM > DIAGNOSIS SYSTEM |
| DESCRIPTION |
Check the battery voltage.
Check the DLC3 (Click here).
| DIAGNOSIS |
![]() |
If the skid control ECU detects a malfunction, the ABS warning, brake warning, slip indicator, and downhill assist control indicator (for 4WD) lights will come on in order to warn the driver.
For vehicles with the multi-information display, the master caution indicator light will come on and a warning message will be displayed on the multi-information display if any of the EBD system, BA system, or TRAC system is malfunctioning or if the ABS control or VSC cannot be performed.
The table below indicates which lights will come on when there is a malfunction in a particular function.
| Item / Trouble Area | ABS | EBD | BA | TRAC | VSC | Downhill assist control (*1) | Hill-start assist control | Skid control ECU |
| ABS warning light | ○ | ○ | ○ | - | - | - | - | ○ |
| Brake warning light | - | ○ | - | - | - | - | - | ○ |
| Slip indicator light | ○ | ○ | ○ | ○ | ○ | ○ | ○ | ○ |
| Downhill assist control indicator light (*1) | ● (Downhill assist control switch ON) | ● (Downhill assist control switch ON) | ● (Downhill assist control switch ON) | ● (Downhill assist control switch ON) | ● (Downhill assist control switch ON) | ● (Downhill assist control switch ON) | ● (Downhill assist control switch ON) | ● (Downhill assist control switch ON) |
| Master caution indicator light (*2) | ○ | ○ | ○ | ○ | ○ | ○ | ○ | ○ |
| Multi-information display (*2) | ○ | ○ | ○ | - | - | ○ | ○ | ○ |
| WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK |
Release the parking brake.
![]() |
When the ignition switch is turned on (IG), check that the ABS warning, brake warning, TRAC OFF indicator, VSC OFF indicator, slip indicator and downhill assist control indicator (for 4WD) lights come on for approximately 3 seconds.
| Trouble Area | See procedure |
| ABS warning light circuit (Remains on) |
Click here
|
| ABS warning light circuit (Does not come on) |
Click here
|
| Brake warning light circuit (Remains on) |
Click here
|
| Brake warning light circuit (Does not come on) |
Click here
|
| TRAC OFF indicator light circuit (Remains on) |
Click here
|
| TRAC OFF indicator light circuit (Does not come on) |
Click here
|
| VSC OFF indicator light circuit (Remains on) |
Click here
|
| VSC OFF indicator light circuit (Does not come on) |
Click here
|
| Slip indicator light circuit (Remains on) |
Click here
|
| Slip indicator light circuit (Does not come on) |
Click here
|
| Downhill assist control indicator light circuit (Remains on) |
Click here
|
| Downhill assist control indicator light circuit (Does not come on) |
Click here
|
| SYMPTOM SIMULATION |
![]() |
Vibration method: When vibration seems to be the major cause.
Slightly vibrate the part of the sensor considered to be the problem cause with your fingers and check whether the malfunction occurs.
Slightly shake the connector vertically and horizontally.
Slightly shake the wire harness vertically and horizontally. The connector joint and fulcrum of the vibration are the major areas to be checked thoroughly.