DTC C1290 Steering Angle Sensor Zero Point Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| C1290 | The newly acquired steering angle sensor zero point vastly differs from the previous one. |
|
| 1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR |
Perform zero point calibration of the yaw rate and acceleration sensor (Click here).
| NEXT | |
| 2.CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION |
Turn the ignition switch off.
Start the engine.
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.
Check that the center position of the steering wheel is correctly set while driving straight ahead.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Start the engine.
Drive the vehicle and turn the steering wheel to the right and left at a speed of 35 km/h (22 mph) or more.
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC (C1290) is not output | A |
| DTC (C1290) is output | B |
|
| ||||
| A | ||
| ||