Home › ENGINE › 2GR-FE ENGINE CONTROL SYSTEM › ECM

ECM > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 ECM BRACKET


    A171738
  1. Install the 2 screws and No. 2 ECM bracket.



2. INSTALL NO. 1 ECM BRACKET


    A171737
  1. Install the 2 screws and No. 1 ECM bracket.



3. INSTALL ECM


    A171719
  1. Install the 2 nuts, bolt and ECM.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Install the wire harness clamp.

  1. Connect the 5 ECM connectors.

  1. Install the harness connector.



4. INSTALL TIRE PRESSURE WARNING ECU


    C165672
  1. Connect the connector to the tire pressure warning ECU.



    C165671
  1. Install the tire pressure warning ECU with the nut.

    Torque:
    8.5 N*m{ 87 kgf*cm , 75 in.*lbf }



5. INSTALL CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (w/ Smart Key System)


    B170919
  1. Install the certification ECU (smart key ECU assembly) with the 2 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Connect the connectors.



6. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
  1. Connect each connector and clamp.



    B168370
  1. Engage the 4 claws and 3 clips.

  1. Install the lower instrument panel sub-assembly with the 2 bolts <B> and 3 screws <F>.



7. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    B173000
  1. Engage the 2 guides.

  1. Engage the 3 claws and install the No. 2 instrument panel under cover sub-assembly.



8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:
Use the same procedures for the RH side and the LH side .



9. INSTALL FRONT DOOR SCUFF PLATE RH

HINT:
Use the same procedures for the RH side and the LH side .



10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



11. RESISTER TRANSMITTER ID

NOTICE:
If the tire pressure warning ECU is replaced, resister the transmitter ID (Click here).



12. INSPECT TIRE PRESSURE WARNING SYSTEM

NOTICE:
If the tire pressure warning ECU is replaced, inspect the tire pressure warning system (Click here).



13. INITIALIZE TIRE PRESSURE WARNING SYSTEM

NOTICE:
  1. Be sure to register the transmitter IDs of all tires in the ECU before initialization.
  2. Be sure to inflate all tires to the proper inflation pressure before initialization.

HINT:
Click here



14. REGISTER IMMOBILISER COMMUNICATION ID

NOTICE:
If the ECM is replaced, register the ECU communication ID for the immobiliser system (Click here w/ Smart Key System, Click here w/o Smart Key System).



15. PERFORM INITIALIZATION

NOTICE:
If the ECM is replaced, perform RESET MEMORY (AT initialization) (Click here).