CAN COMMUNICATION SYSTEM > Check CAN Bus Lines for Short Circuit |
| Symptom | Trouble Area |
| Resistance between terminals 6 (CANH) and 14 (CANL) of DLC3 is below 54 Ω. |
|


| 1.CHECK FOR SHORT IN CAN BUS WIRES (CAN JUNCTION CONNECTOR CTR) |
Turn the ignition switch off.
Disconnect the CAN junction connector CTR.
Measure the resistance according to the value(s) in the table below.

| Tester Connection | Wiring Color | Connect to | Condition | Specified Condition |
| D55-1 (CANH) - D55-12 (CANL) | SB - W | CAN junction connector RH | Ignition switch off | 108 to 132 Ω |
| D55-4 (CANH) - D55-15 (CANL) | L - W | DLC3 | Ignition switch off | 1 MΩ or higher |
| D55-6 (CANH) - D55-17 (CANL) | P - W | Combination meter | Ignition switch off | 108 to 132 Ω |
| Result | Proceed to |
| OK | A |
| NG (DLC3 branch wire) | B |
| NG (Combination meter main wire) | C |
| NG (CAN junction connector RH main wire) | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.CHECK FOR SHORT IN CAN BUS WIRES (CAN JUNCTION CONNECTOR CTR) |
Measure the resistance according to the value(s) in the table below.

| Tester Connection | Wiring Color | Connect to | Condition | Specified Condition |
| D55-2 (CANH) - D55-13 (CANL) | V - W | Yaw rate sensor | Ignition switch off | 1 MΩ or higher |
| D55-3 (CANH) - D55-14 (CANL) | Y - W | Center airbag sensor assembly | Ignition switch off | 1 MΩ or higher |
| D55-5 (CANH) - D55-16 (CANL) | R - W | Steering angle sensor | Ignition switch off | 1 MΩ or higher |
| Result | Proceed to |
| OK | A |
| NG (Yaw rate sensor branch wire) | B |
| NG (Center airbag sensor assembly branch wire) | C |
| NG (Steering angle sensor branch wire) | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 3.CHECK FOR SHORT IN CAN BUS WIRES (CAN JUNCTION CONNECTOR CTR) |
Measure the resistance according to the value(s) in the table below.

| Tester Connection | Wiring Color | Connect to | Condition | Specified Condition |
| D55-7 (CANH) - D55-18 (CANL) | BR - W | Power steering ECU | Ignition switch off | 1 MΩ or higher |
| D55-8 (CANH) - D55-19 (CANL) | GR - W | Main body ECU | Ignition switch off | 1 MΩ or higher |
| Result | Proceed to |
| OK | A |
| NG (Power steering ECU branch wire) | B |
| NG (Main body ECU branch wire) | C |
|
| ||||
|
| ||||
| A | ||
| ||
| 4.CHECK FOR SHORT IN CAN BUS WIRES (COMBINATION METER ECU MAIN WIRE) |
![]() |
Disconnect the combination meter connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D55-6 (CANH) - D55-17 (CANL) | Ignition switch off | 1 MΩ or higher |
|
| ||||
| OK | ||
| ||
| 5.CHECK FOR SHORT IN CAN BUS WIRES (CAN JUNCTION CONNECTOR RH) |
Disconnect the CAN junction connector RH.
Measure the resistance according to the value(s) in the table below.

| Tester Connection | Wiring Color | Connect to | Condition | Specified Condition |
| D59-1 (CANH) - D59-12 (CANL) | R - W | ECM | Ignition switch off | 108 to 132 Ω |
| D59-5 (CANH) - D55-16 (CANL) | SB - W | CAN junction connector CTR | Ignition switch off | 1 MΩ or higher |
| Result | Proceed to |
| OK | A |
| NG (ECM main wire) | B |
| NG (CAN junction connector main wire) | C |
|
| ||||
|
| ||||
| A | |
| 6.CHECK FOR SHORT IN CAN BUS WIRES (CAN JUNCTION CONNECTOR RH) |
Measure the resistance according to the value(s) in the table below.

| Tester Connection | Wiring Color | Connect to | Condition | Specified Condition |
| D59-2 (CANH) - D59-13 (CANL) | BR - W | Accessory gateway | Ignition switch off | 1 MΩ or higher |
| D59-3 (CANH) - D59-14 (CANL) | LG - W | Air conditioning amplifier | Ignition switch off | 1 MΩ or higher |
| D59-4 (CANH) - D59-15 (CANL) | B - W | Skid control ECU | Ignition switch off | 1 MΩ or higher |
| Result | Proceed to |
| OK | A |
| NG (Accessory gateway branch wire) | B |
| NG (Air conditioning amplifier branch wire) | C |
| NG (Skid control ECU branch wire) | D |
|
| ||||
|
| ||||
|
| ||||
| A | ||
| ||
| 7.CHECK FOR SHORT IN CAN BUS WIRES (ECM MAIN WIRE) |
![]() |
Disconnect the ECM connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D59-1 (CANH) - D59-12 (CANL) | Ignition switch off | 1 MΩ or higher |
|
| ||||
| OK | ||
| ||
| 8.CHECK FOR SHORT IN CAN BUS WIRES (YAW RATE SENSOR BRANCH WIRE) |
![]() |
Disconnect the yaw rate sensor connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D55-2 (CANH) - D55-13 (CANL) | Ignition switch off | 1 MΩ or higher |
|
| ||||
| OK | ||
| ||
| 9.CHECK FOR SHORT IN CAN BUS WIRES (CENTER AIRBAG SENSOR ASSEMBLY BRANCH WIRE) |
![]() |
Disconnect the center airbag sensor assembly connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D55-3 (CANH) - D55-14 (CANL) | Ignition switch off | 1 MΩ or higher |
|
| ||||
| OK | ||
| ||
| 10.CHECK FOR SHORT IN CAN BUS WIRES (STEERING ANGLE SENSOR BRANCH WIRE) |
![]() |
Disconnect the steering angle sensor connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D55-5 (CANH) - D55-16 (CANL) | Ignition switch off | 1 MΩ or higher |
|
| ||||
| OK | ||
| ||
| 11.CHECK FOR SHORT IN CAN BUS WIRES (POWER STEERING ECU BRANCH WIRE) |
![]() |
Disconnect the power steering ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D55-7 (CANH) - D55-18 (CANL) | Ignition switch off | 1 MΩ or higher |
|
| ||||
| OK | ||
| ||
| 12.CHECK FOR SHORT IN CAN BUS WIRES (MAIN BODY ECU BRANCH WIRE) |
![]() |
Disconnect the main body ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D55-8 (CANH) - D55-19 (CANL) | Ignition switch off | 1 MΩ or higher |
|
| ||||
| OK | ||
| ||
| 13.CHECK FOR SHORT IN CAN BUS WIRES (AIR CONDITIONING AMPLIFIER BRANCH WIRE) |
![]() |
Disconnect the air conditioning amplifier connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D59-3 (CANH) - D59-14 (CANL) | Ignition switch off | 1 MΩ or higher |
|
| ||||
| OK | ||
| ||
| 14.CHECK FOR SHORT IN CAN BUS WIRES (SKID CONTROL ECU BRANCH WIRE) |
![]() |
Disconnect the skid control ECU connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D59-4 (CANH) - D59-15 (CANL) | Ignition switch off | 1 MΩ or higher |
|
| ||||
| OK | ||
| ||
| 15.CHECK FOR SHORT IN CAN BUS WIRES (ACCESSORY GATEWAY BRANCH WIRE) |
Disconnect the accessory gateway connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D59-2 (CANH) - D59-13 (CANL) | Ignition switch off | 1 MΩ or higher |
|
| ||||
| OK | ||
| ||