VEHICLE STABILITY CONTROL SYSTEM > VSC OFF Indicator Light Remains ON |

| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK IF SKID CONTROL ECU CONNECTOR IS SECURELY CONNECTED |
Check if the skid control ECU connector is securely connected.
|
| ||||
| OK | |
| 3.CHECK BATTERY |
Check the battery voltage.
|
| ||||
| OK | |
| 4.READ VALUE ON TECHSTREAM (VSC OFF SWITCH) |
Connect Techstream to the DLC3.
Turn the ignition switch on (IG).
Select the Data List mode on Techstream (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| TRC/VSC Off Mode | VSC OFF switch / NORMAL, TRC OFF or VSC OFF | NORMAL: Normal TRC OFF: TRAC off mode VSC OFF: VSC off mode | - |
Using Techstream, check the switch condition on Techstream changes according to VSC OFF switch operation.
|
| ||||
| OK | |
| 5.INSPECT COMBINATION METER ASSEMBLY |
Turn the ignition switch off.
Perform the Active Test of the combination meter (meter CPU) using Techstream (Click here).
Check the combination meter.
|
| ||||
| OK | ||
| ||
| 6.INSPECT VSC OFF SWITCH |
![]() |
Turn the ignition switch off.
Disconnect the VSC OFF switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 6 (+) - 3 (E) | Switch is pushed in | Below 25 Ω |
| 6 (+) - 3 (E) | Switch is not pushed in | 10 kΩ or higher |
|
| ||||
| OK | |
| 7.CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - VSC OFF SWITCH) |
![]() |
Disconnect the skid control ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A24-30 (CSW) - D43-6 (+) | Always | Below 1 Ω |
| A24-30 (CSW) - Body ground | Always | 10 kΩ or higher |
| D43-3 (E) - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||