VEHICLE STABILITY CONTROL SYSTEM > VSC OFF Indicator Light does not Come ON |
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (VSC OFF INDICATOR LIGHT) |
Connect Techstream to the DLC3.
Start the engine.
Select the Active Test mode on Techstream (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| VSC OFF Indicator Light | VSC OFF indicator light | Indicator light ON / OFF | Observe combination meter |
Check that the VSC OFF indicator light on the combination meter turns on or off in accordance with Techstream operation.
|
| ||||
| OK | ||
| ||
| 3.INSPECT COMBINATION METER ASSEMBLY |
Turn the ignition switch off.
Perform the Active Test of the combination meter (meter CPU) using Techstream (Click here).
Check the combination meter.
|
| ||||
| OK | ||
| ||