Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

VEHICLE STABILITY CONTROL SYSTEM > Downhill Assist Control Indicator Light does not Come ON

for Preparation Click here


DESCRIPTION

The skid control ECU is connected to the combination meter via CAN communication.

WIRING DIAGRAM

Refer to Downhill Assist Control Indicator Light Remains ON .

INSPECTION PROCEDURE

NOTICE:
When replacing the brake actuator assembly, perform zero point calibration (Click here).

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if a CAN communication system DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
INSPECT CAN COMMUNICATION SYSTEM (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM (DOWNHILL ASSIST CONTROL INDICATOR LIGHT)
  1. Connect Techstream to the DLC3.

  1. Start the engine.

  1. Select the Active Test mode on Techstream (Click here).

    ABS / VSC / TRAC: 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Downhill Assist Control Light
    Downhill assist control indicator light
    Indicator light ON / OFF
    Observe combination meter

  1. Check that the downhill assist control indicator light on the combination meter turns on or off in accordance with Techstream operation.

    OK:
    The downhill assist control indicator light turns on or off in accordance with Techstream operation.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part (Click here).



NG
Go to step 3
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)  

3.INSPECT COMBINATION METER ASSEMBLY
  1. Turn the ignition switch off.

  1. Perform the Active Test of the combination meter (meter CPU) using Techstream (Click here).

  1. Check the combination meter.

    OK:
    The downhill assist control indicator light turns on or off in accordance with Techstream operation.

    HINT:
    If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step (Click here).



NG
REPLACE COMBINATION METER ASSEMBLY (Click here)
OK

REPLACE BRAKE ACTUATOR ASSEMBLY (Click here)