Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Light Circuit

for Preparation Click here


DESCRIPTION

If the ECU detects any trouble, the tire pressure warning light blinks (stays on after blinking for 1 minute) and tire pressure monitor is cancelled at the same time. At this time, the ECU records a DTC in the memory.
Connecting terminals TC and CG of the DLC3 makes the tire pressure warning light blink to output DTCs.

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using the Techstream and write them down before removal.
  1. It is necessary to perform registration (Click here) of the transmitter IDs into the tire pressure warning ECU, after the ECU has been replaced.

1.CHECK CAN COMMUNICATION LINE
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG) and turn the Techstream on.

  1. Enter the following menus:
    Select: "Bus Check" from the "System Select" / "Communication Malfunction DTC" from the "Bus Check" screen

  1. Check the CAN communication system (Click here).



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.CHECK DTC (CAN COMMUNICATION SYSTEM)
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG) and turn the Techstream on.

  1. Check for DTCs.

    Result:
    Result
    Proceed to
    CAN system DTC is not output
    A
    CAN system DTC is output
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


3.PERFORM ACTIVE TEST USING TECHSTREAM (COMBINATION METER)
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG) and turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. Check the condition of the tire pressure warning light by operating the Techstream.

    Combination Meter  
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Tire Pressure Warning System
    Tire Pressure Warning Light
    Tire pressure warning light is OFF/ON
    Confirm that the vehicle is stopped, engine idling

OK:
The warning light turns on or off according to the Techstream operation.



NG
GO TO COMBINATION METER (Click here)
OK

REPLACE TIRE PRESSURE WARNING ECU (Click here)