Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING SYSTEM

DTC    C2179/79    Tire Pressure Monitor ECU Communication Stop

for Preparation Click here


DESCRIPTION

The tire pressure warning ECU receives speed signals from the combination meter via CAN communication.

DTC Code
DTC Detection Condition
Trouble Area
C2179/79
Tire pressure warning ECU communication disruption
  1. CAN communication system
  2. Vehicle speed signal circuit
  3. Combination meter
  4. Tire pressure warning ECU

INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the IDs stored in the old ECU using Techstream and write them down before removal.
  2. It is necessary to perform registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.

1.CHECK CAN COMMUNICATION SYSTEM
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG) and turn the Techstream on.

  1. Enter the following menus:
    Select: "Bus Check" from the "System Select" / "Communication Malfunction DTC" from the "Bus Check" screen

  1. Check the CAN communication system (Click here).



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.CHECK VEHICLE SPEED SIGNAL (DATA LIST)
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG) and turn the Techstream on.

  1. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.

  1. Check that the values indicated on the Techstream and on the combination meter are the same.

    Tire Pressure Monitor:

    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Vehicle Speed
    Vehicle speed reading/
    min.: 0 km/h (0 mph)
    max.: 255 km/h (158 mph)
    Actual vehicle speed
    Speed indicated on the combination meter

    OK:
    The vehicle speed displayed on the Techstream changes depending on the actual vehicle speed.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


3.PERFORM SIGNAL CHECK (VEHICLE SPEED SIGNAL)
  1. Enter the signal check mode in TEST MODE PROCEDURE (Click here).

  1. Drive the vehicle at 20 km/h (12 mph) or more for 3 seconds to erase DTC C2191/91.

  1. Check the test mode DTCs.

    Result:
    Result
    Proceed to
    DTC C2191/91 is erased
    A
    DTC C2191/91 is output
    B



B
REPLACE TIRE PRESSURE WARNING ECU (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)