1.REMOVE FRONT SEAT ASSEMBLY LH
Use the same procedure as for LHD.
for Manual Seat: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL
for Power Seat: Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL
73900
2.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
58810J
3.REMOVE CONSOLE BOX ASSEMBLY
Use the same procedure as for LHD.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>FRONT CONSOLE BOX>REMOVAL
4.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Disconnect the front door opening trim weatherstrip LH to the extent that allows the removal of the center pillar lower garnish LH.
72138M
5.REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH
67918A
6.REMOVE REAR DOOR SCUFF PLATE LH
7.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
Disconnect the rear door opening trim weatherstrip LH to the extent that allows the removal of the center pillar lower garnish LH.
62414A
8.REMOVE LOWER CENTER PILLAR GARNISH LH
73220
9.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH
58510D
10.SEPARATE FRONT FLOOR CARPET ASSEMBLY
Disengage the 3 floor carpet hooks to separate the front floor carpet assembly.
58817A
11.REMOVE FRONT NO. 2 CONSOLE BOX INSERT
Use the same procedure as for LHD.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
87213
12.REMOVE REAR NO. 2 AIR DUCT
87212
13.REMOVE REAR NO. 1 AIR DUCT
55215A
14.REMOVE NO. 3 DASH PANEL INSULATOR PAD
Disengage the 2 clips and remove the No. 3 dash panel insulator pad.
58563Q
15.DISCONNECT FRONT NO. 3 FLOOR SILENCER
Disconnect the front No. 3 floor silencer to the extent that allows the removal of the parking brake control pedal assembly.
58166
16.REMOVE FRONT FLOOR COVER LH
|
Bolt |
|
Screw |
Remove the 4 bolts, 2 screws and clip (A).
Disengage the 2 clips (B) and remove the front floor cover LH.
58167A
17.REMOVE FRONT CENTER FLOOR COVER
|
Nut |
|
Screw |
Remove the nut and 2 screws.
Disengage the 4 clips and remove the front center floor cover.
58730
18.REMOVE REAR ENGINE SERVICE COVER ASSEMBLY
Remove the 2 bolts and rear engine service cover assembly from the body.
46441
19.LOOSEN NO. 1 WIRE ADJUSTING NUT
Completely release the parking brake pedal.
| *1 | Lock Nut |
| *2 | No. 1 Wire Adjusting Nut |
Remove the lock nut and loosen No. 1 wire adjusting nut to completely release the parking brake cable.
46430
20.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
Separate the No. 3 parking brake cable assembly from the parking brake equalizer.
46420
21.SEPARATE NO. 2 PARKING BRAKE CABLE ASSEMBLY
Perform the same procedure as for the No. 3 parking brake cable assembly.
46341
22.REMOVE PARKING BRAKE EQUALIZER
Slide the rubber boot as shown in the illustration.
Remove the parking brake equalizer from the No. 1 parking brake cable assembly as shown in the illustration.
46200
23.REMOVE PARKING BRAKE CONTROL PEDAL ASSEMBLY
Remove the 2 bolts, 3 nuts and separate the No. 1 parking brake cable assembly from the body.
Disengage the clamp.
Pull out the No. 1 parking brake cable assembly toward the cabin.
Disconnect the parking brake switch connector.
Remove the 3 nuts and parking brake control pedal assembly from the body.