When an incorrect ECM is installed after the assist map has been written to the power steering ECU assembly, then DTC C1582 is stored because the data does not match the vehicle specifications.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Note |
|---|---|---|---|---|---|
| C1582 | Assist Map Number Mismatch | Assist map number mismatch | ·
CAN communication system ·
Incorrect ECM ·
Power steering ECU assembly |
EPS warning light: Does not come on | - |
If the power steering ECU assembly has been replaced, perform assist map writing.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
Related parts store information necessary for assist map writing.
Related Part:
ECM
Check for DTCs.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| CAN communication system DTCs are not output. | A |
| CAN communication system DTCs are output. | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check if the part below has been replaced with an incorrect part in the past.
| Related Part | ECM |
When removing the related part to check it, be sure to follow the appropriate procedures and precautions.
ECM
for 1AR-FE: Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>ECM>REMOVAL
for 2GR-FKS: Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>ECM>REMOVAL
When DTC C1582 is output and parts have not been exchanged, replace the power steering ECU assembly as it may have an internal malfunction.
If the power steering ECU assembly has been replaced, perform assist map writing.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
| Result | Proceed to |
|---|---|
| The related part has an incorrect part number. | A |
| The related part has the correct part number, or a related part and power steering ECU assembly have not been replaced. | B |
A
B
Replace the related part with one that has the correct part number.
ECM
for 1AR-FE: Click hereEngine / Hybrid System>1AR-FE ENGINE CONTROL>ECM>REMOVAL
for 2GR-FKS: Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTCs are not output. | A |
| DTCs are output. | B |
A
B