30500
1.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD)
When not Using the Engine Support Bridge: Click hereDrivetrain>UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE ASSEMBLY(When Not Using the Engine Support Bridge)>REMOVAL
When Using the Engine Support Bridge: Click hereDrivetrain>UA80E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE ASSEMBLY(When Using the Engine Support Bridge)>REMOVAL
30500
2.REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for AWD)
When not Using the Engine Support Bridge: Click hereDrivetrain>UA80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE ASSEMBLY(When Not Using the Engine Support Bridge)>REMOVAL
When Using the Engine Support Bridge: Click hereDrivetrain>UA80F (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE ASSEMBLY(When Using the Engine Support Bridge)>REMOVAL
32101
3.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
Using SST, hold the crankshaft pulley.
Remove the 8 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly and the No. 1 crankshaft position sensor plate.
11381A
4.REMOVE REAR ENGINE OIL SEAL
| *a | Protective Tape |
| *b | Cut Position |
Using a knife, cut through the lip of the rear engine oil seal.
Using a screwdriver with its tip wrapped with protective tape, pry out the rear engine oil seal.
Be careful not to damage the crankshaft.