1.INSTALL ENGINE ASSEMBLY TO ENGINE STAND (When Not Using the Engine Support Bridge)
2.DRAIN ENGINE OIL (When Using the Engine Support Bridge)
51100G
3.REMOVE FRONT FRAME ASSEMBLY (When Using the Engine Support Bridge)
30500
4.SUPPORT AUTOMATIC TRANSAXLE ASSEMBLY (When Using the Engine Support Bridge)
Set an engine lifter.
To prevent the engine assembly with automatic transaxle assembly from falling while servicing, do not remove SST.
Make sure that there is clearance between the automatic transaxle assembly and engine lifter.
5.REMOVE BELT (When Using the Engine Support Bridge)
12102A
6.REMOVE NO. 2 OIL PAN SUB-ASSEMBLY
15104
7.REMOVE OIL STRAINER SUB-ASSEMBLY
89491
8.REMOVE ENGINE OIL LEVEL SENSOR
Remove the clip from the engine oil level sensor.
Remove the 2 nuts and engine oil level sensor from the oil pan sub-assembly.