Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB › from 2018.09
RM3160E _52 Drivetrain _019687 AXLE AND DIFFERENTIAL _0109439 REAR AXLE HUB A

AXLE AND DIFFERENTIAL  REAR AXLE HUB  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (for 2WD)

a.
C293046

Install the rear axle hub and bearing assembly to the rear axle carrier sub-assembly with the 4 bolts.

Torque:
125 N*m (1275 kgf*cm, 92 ft.*lbf)


Hide 42440 2.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY (for AWD)

a.
C293044C01
3.177,1.521 3.177,0.375 3.177,0.375 2.875,0.375 true 3.021,0.708 3.167,0.708 true 3.083,1.531 3.396,1.688 0.313,0.156 10 false *a
*a Matchmark


Install the rear axle hub and bearing assembly to the rear drive shaft assembly.

NOTICE:

Align the matchmarks on the rear drive shaft assembly and rear axle hub and bearing assembly.



b.
C293047

Install the rear axle hub and bearing assembly to the rear axle carrier sub-assembly with the 4 bolts.

Torque:
125 N*m (1275 kgf*cm, 92 ft.*lbf)


Hide 42312B 3.TEMPORARILY INSTALL REAR AXLE SHAFT NUT (for AWD)

a.

Clean the threaded parts on the rear drive shaft assembly and a new rear axle shaft nut using non-residue solvent.

NOTICE:
·

Be sure to perform this work even when using a new rear drive shaft assembly.

·

Keep the threaded parts free of oil and foreign matter.




b.

Temporarily install the rear disc with the 5 hub nuts.


c.
C296194

Using a 30 mm socket wrench, while applying the parking brakes, temporarily install the rear axle shaft nut.

Torque:
294 N*m (2998 kgf*cm, 217 ft.*lbf)

NOTICE:

Stake the rear axle shaft nut after inspecting for looseness and runout in the following steps.



d.

Remove the 5 hub nuts and the rear disc.


Hide 4.INSPECT REAR AXLE HUB BEARING LOOSENESS

Hide 89516B 6.INSTALL SKID CONTROL SENSOR WIRE (for 2WD)

Hide 89546 7.INSTALL REAR SPEED SENSOR (for AWD)

a.
C293840

Install the rear speed sensor to the rear axle carrier sub-assembly with the bolt.

Torque:
8.5 N*m (87 kgf*cm, 75 in.*lbf)

NOTICE:

Do not twist the rear speed sensor when installing it.



Hide 42431 8.INSTALL REAR DISC

Hide 42491 9.INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 10.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42312B 11.STAKE REAR AXLE SHAFT NUT (for AWD)

a.
C296159

Using a chisel and hammer, stake the rear axle shaft nut.


Hide 12.ADJUST PARKING BRAKE

Hide 13.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)