Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR(for 2WD) › from 2018.09
RM3160E _54 Brake _019692 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0108078 REAR SPEED SENSOR(for 2WD) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR(for 2WD)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.

·

The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

·

If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.



PROCEDURE

Hide 42450B 1.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

a.

Install the rear axle hub and bearing assembly.

Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB>INSTALLATION

HINT:
·

The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

·

If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.




Hide 2.INSPECT REAR AXLE HUB BEARING LOOSENESS

Hide 89516B 4.INSTALL SKID CONTROL SENSOR WIRE

a.

Connect the connector to the rear speed sensor.

NOTICE:

Do not twist the skid control sensor wire.



b.

Install the skid control sensor wire with the bolt.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


Hide 42431 5.INSTALL REAR DISC

Hide 42491 6.INSTALL PARKING BRAKE SHOE ADJUSTING HOLE PLUG

Hide 7.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 8.ADJUST PARKING BRAKE

Hide 9.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION