Home › Vehicle Interior › HEATING / AIR CONDITIONING › FRONT AIR CONDITIONING UNIT (for Gasoline Model) › 2020.02–2020.11
RM37A0E _58 Vehicle Interior _086896 HEATING / AIR CONDITIONING _0417362 FRONT AIR CONDITIONING UNIT(for Gasoline Model) A

HEATING / AIR CONDITIONING  FRONT AIR CONDITIONING UNIT(for Gasoline Model)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during air conditioning unit removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for Gasoline Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

*: Even when not replacing the part, it is necessary to perform the specified necessary procedures after installation.

*1: Learning can also be performed using the GTS.

Click here(Click here)

Disconnect cable from negative auxiliary battery terminal Perform steering sensor zero point calibration Lane Control System (Click here)
Parking Support Brake System*1
Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System (Click here)
Panoramic View Monitor System (Click here)
Initialize back door lock Power Door Lock Control System (Click here)
Reset back door close position Power Back Door System (Click here)
Steering sensor* Steering angle setting Parking Assist Monitor System (Click here)
Adjust steering angle Panoramic View Monitor System (Click here)
Steering angle neutral point Parking Assist Monitor System (Click here)
Parking Support Brake System (Click here)
Panoramic View Monitor System (Click here)

CAUTION:
B401522

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


NOTICE:

After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

Make sure to select face mode before disconnecting the cable from the negative (-) battery terminal.


Hide 2.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

Hide 3.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

Hide 53808A 4.REMOVE FENDER SPLASH SHIELD SUB-ASSEMBLY REAR LH

Hide 53807A 5.REMOVE FENDER SPLASH SHIELD SUB-ASSEMBLY REAR RH

HINT:

Perform the same procedure as for the LH side.


Hide 53892C 6.REMOVE FRONT FENDER SPLASH SHIELD SEAL FRONT LH

Hide 53891C 7.REMOVE FRONT FENDER SPLASH SHEILD SEAL FRONT RH

HINT:

Perform the same procedure as for the LH side.


Hide 8.REMOVE FRONT UPPER SUSPENSION TO COWL BRACE SUB-ASSEMBLY LH

Hide 53607B 9.REMOVE FRONT UPPER SUSPENSION TO COWL BRACE SUB-ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 55704B 10.REMOVE COWL VENTILATOR PANEL SUB-ASSEMBLY

Hide 88710G 11.DISCONNECT NO. 2 AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY

a.
E431230

Remove the bolt and rotate the hook connector as shown in the illustration.


b.
E431301

Disconnect the No. 2 air conditioner tube and accessory assembly.


c.

Remove the 2 O-rings from the No. 2 air conditioner tube and accessory assembly.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



Hide 87209 12.DISCONNECT WATER HOSE SUB-ASSEMBLY

a.
E431235

Using pliers, grip the claws of the clip and slide the clip to disconnect the water hose sub-assembly.

NOTICE:
·

Do not apply excessive force to the water hose sub-assembly.

·

Prepare a drain pan or cloth in case the coolant leaks.




Hide 87245B 13.DISCONNECT INLET HEATER WATER HOSE B

a.
E431233

Using pliers, grip the claws of the clip and slide the clip to disconnect the inlet heater water hose B.

NOTICE:
·

Do not apply excessive force to the inlet heater water hose B.

·

Prepare a drain pan or cloth in case the coolant leaks.




Hide 14.REMOVE FRONT SEAT ASSEMBLY RH (for Manual Seat)

Hide 15.REMOVE FRONT SEAT ASSEMBLY (for Power Seat)

Hide 16.REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY WITH MAIN BODY ECU

Hide 83108 17.REMOVE METER MIRROR SUB-ASSEMBLY (w/ Headup Display)

Hide 8598A 18.REMOVE DOOR CONTROL BATTERY (w/ Door Control Battery)

Hide 87201L 19.REMOVE NO. 4 AIR DUCT SUB-ASSEMBLY

Hide 45250 20.REMOVE STEERING COLUMN ASSEMBLY

Hide 82877 21.REMOVE ECU INTEGRATION BOX RH

Hide 22.REMOVE PARKING ASSIST ECU WITH BRACKET

Hide 88625Q 24.REMOVE COOLER (ROOM TEMP. SENSOR) THERMISTOR

Hide 78118 25.REMOVE ACCELERATOR PEDAL PAD

Hide 55837C 32.REMOVE CENTER HEATER TO REGISTER SUB DUCT

Hide 33.DISCONNECT INSTRUMENT PANEL WIRE

a.

Disconnect the 2 connectors.

E456768C02
0.396,0.24 0.896,0.458 true 4.115,0.5 4.583,0.281 true 5.854,3.292 6.063,3.219 true 0.74,4.438 0.74,4.219 true 5.854,3.802 6.313,3.667 true 1.865,5.604 1.531,5.458 true 6.698,2.948 6.906,2.875 true 0.208,0.146 0.396,0.354 0.188,0.208 10 true *a 4.594,0.167 4.781,0.375 0.188,0.208 10 true *a 5.635,3.677 5.823,3.885 0.188,0.208 10 true *a 0.656,4.396 0.844,4.604 0.188,0.208 10 true *a 5.625,3.208 5.813,3.417 0.188,0.208 10 true *b 1.885,5.51 2.073,5.719 0.188,0.208 10 true *a 6.906,2.771 7.156,2.979 0.25,0.208 12 true *A
*A w/ Airbag Cut Off Switch - -
*a Earth Wire *b Connector Holder
V100135

Bolt (A)
V100136

Bolt (B)
V100137

Connector
V100138

Nut



b.

Remove the 5 bolts (A) and disconnect the 5 earth wires.


c.

Remove the 2 nuts.


d.

Remove the bolt (B) and disconnect the connector holder.


e.

Disengage each clamp.


f.
E434825C01
1.677,2.938 2.5,2.344 true 1.469,2.833 1.781,2.99 0.313,0.156 10 false *a
*a Earth Wire
V100135

Connector
V100136

Bolt


Disconnect the 2 connectors.


g.

Disengage each clamp.


h.

Remove the bolt and disconnect the earth wire.


Hide 55306A 34.REMOVE NO. 1 INSTRUMENT PANEL BRACE SUB-ASSEMBLY

Hide 55307C 35.REMOVE NO. 2 INSTRUMENT PANEL BRACE SUB-ASSEMBLY

Hide 36.REMOVE INSTRUMENT PANEL REINFORCEMENT ASSEMBLY WITH AIR CONDITIONER UNIT ASSEMBLY