44785
1.INSTALL BRAKE BOOSTER GASKET
Install a new brake booster gasket to the brake booster assembly.
44610
2.INSTALL BRAKE BOOSTER ASSEMBLY
Temporarily install the brake booster assembly to the vehicle body.
Do not apply excessive force to the brake lines.
Temporarily install the lock nut and brake master cylinder push rod clevis to the brake booster assembly.
Fully tighten the lock nut when adjusting the brake pedal height.
Install the 4 nuts to secure the brake booster assembly.
3.CONNECT CONNECTOR
Connect the connector.
44778
4.CONNECT CONNECTOR TO CHECK VALVE HOSE
| *a | Paint Mark |
Connect the connector to check valve hose to the brake booster assembly, and slide the clip to secure it.
When connecting the connector to check valve hose, face the paint mark up.
Make sure that the tabs of the clip are facing upward.
47264A
5.INSTALL PUSH ROD PIN
73900
6.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
55446A
7.INSTALL NO. 1 SWITCH HOLE BASE
55045
8.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
53601
9.CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
10.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
11.INSPECT AND ADJUST BRAKE PEDAL
55606
12.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
62112A
13.INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH
67914
14.INSTALL FRONT DOOR SCUFF PLATE LH
55704B
15.INSTALL COWL VENTILATOR PANEL SUB-ASSEMBLY
16.INSTALL FRONT UPPER SUSPENSION TO COWL BRACE SUB-ASSEMBLY LH
53607B
17.INSTALL FRONT UPPER SUSPENSION TO COWL BRACE SUB-ASSEMBLY RH
Perform the same procedure as for the LH side.
53892C
18.INSTALL FRONT FENDER SPLASH SHIELD SEAL FRONT LH
53891C
19.INSTALL FRONT FENDER SPLASH SHIELD SEAL FRONT RH
Perform the same procedure as for the LH side.
53808A
20.INSTALL FENDER SPLASH SHIELD SUB-ASSEMBLY REAR LH
53807A
21.INSTALL FENDER SPLASH SHIELD SUB-ASSEMBLY REAR RH
Perform the same procedure as for the LH side.
22.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
23.INSPECT SRS WARNING LIGHT