Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model) › 2020.02–2020.11
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0420942 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for Gasoline Model)  C05121F  Right Rear Wheel Speed Sensor Circuit Intermittent  


DESCRIPTION

Refer to DTC C051212.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>C051212

DTC No. Detection Item DTC Detection Condition Trouble Area
C05121F Right Rear Wheel Speed Sensor Circuit Intermittent Any of the following is detected:
·

When the +BS terminal voltage is 17.4 V or less, an open in the sensor signal circuit of a malfunctioning area occurs 255 times or more.

·

When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 20 km/h (12 mph) or more, noise occurs in the sensor signals of a malfunctioning wheel 75 times or more within 5 seconds.

·

When the +BS terminal voltage is 17.4 V or less at a vehicle speed of 10 km/h (6 mph) or more, noise occurs once per rotor rotation for 15 seconds or more.


·

Rear skid control sensor RH

·

Rear skid control sensor installation

·

Rear speed sensor rotor RH (rear axle hub and bearing assembly RH)



CAUTION / NOTICE / HINT

NOTICE:
·

After replacing or removing and installing a skid control sensor, perform Dealer Mode (Signal Check) inspection to confirm that the skid control sensors are operating correctly.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>TEST MODE PROCEDURE

·

After replacing or removing and installing a speed sensor rotor, perform Dealer Mode (Signal Check) inspection to confirm that the skid control sensors are operating correctly.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>TEST MODE PROCEDURE



PROCEDURE

1.READ VALUE USING GTS (RR WHEEL SPEED, MOMENTARY INTERRUPTION)
a.

While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>DATA LIST / ACTIVE TEST

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
RR Wheel Speed Rear skid control sensor RH reading Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
RR Speed Open Rear skid control sensor RH open detection Normal / Under intermittent Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
-
Chassis > Brake/EPB > Data List
Tester Display
RR Wheel Speed
RR Speed Open
50003 435 15,103
OK:

The values change in accordance with the operation of the vehicle and there is no intermittent operation.


NOTICE:

Perform the above inspection before removing the sensor and connector.



Result:
Proceed to
OK
NG



OK

NG

2.CHECK REAR SKID CONTROL SENSOR RH INSTALLATION
2.CHECK REAR SKID CONTROL SENSOR RH INSTALLATION
a.
C168336C10
1.031,0.823 1.25,0.49 false 0.917,1.49 1.24,1.74 false 0.75,1.823 1.073,1.99 0.323,0.167 10 *a 2.427,1.823 2.75,1.99 0.323,0.167 10 *b 0.135,0.135 0.448,0.333 0.313,0.198 10 *1 1.292,0.313 1.625,0.521 0.333,0.208 10 *c 1.292,1.729 1.604,1.927 0.313,0.198 10 *d
*1 Rear Skid Control Sensor RH
*a Correct
*b Incorrect
*c 8.5 N*m (87 kgf*cm, 75 in.*lbf)
*d No clearance


Turn the ignition switch off.


b.

Check the rear skid control sensor RH installation.

OK:

There is no clearance between the rear skid control sensor RH and the rear axle carrier RH.

The installation bolt is tightened properly.

Torque:

8.5 N*m (87 kgf*cm, 75 in.*lbf)



Result:
Proceed to
OK
NG



OK

3.CHECK REAR SKID CONTROL SENSOR RH (CHECK FOR FOREIGN MATTER)

NG

3.CHECK REAR SKID CONTROL SENSOR RH (CHECK FOR FOREIGN MATTER)
a.

Remove the rear skid control sensor RH, and confirm that there is no foreign matter, oil or grease on the rear skid control sensor tip RH.

OK:

The rear skid control sensor tip RH is free of oil and foreign matter.


HINT:

If foreign matter of 1mm x 1mm or more is adhered to the rear skid control sensor RH, this DTC may be stored.



Result:
Proceed to
OK
NG



OK

4.CHECK REAR SPEED SENSOR ROTOR RH (CHECK FOR FOREIGN MATTER)

NG

7.CLEAN REAR SKID CONTROL SENSOR RH
4.CHECK REAR SPEED SENSOR ROTOR RH (CHECK FOR FOREIGN MATTER)
a.

Confirm that there is no foreign matter, oil or grease on the rear speed sensor rotor RH.

OK:

The rear speed sensor rotor RH is free of oil and foreign matter.


HINT:
·

If foreign matter of 1mm x 1mm or more is adhered to the rear speed sensor rotor RH, this DTC may be stored.

·

The rear speed sensor rotor RH is incorporated into the rear axle hub and bearing assembly RH.

·

If the rear speed sensor rotor RH needs to be replaced, replace it together with the rear axle hub and bearing assembly RH.




Result:
Proceed to
OK
NG



OK

REPLACE REAR SKID CONTROL SENSOR RH AND REAR SPEED SENSOR ROTOR RH

NG

5.CLEAN REAR SPEED SENSOR ROTOR RH
5.CLEAN REAR SPEED SENSOR ROTOR RH
a.

Clean the rear speed sensor rotor RH.

NOTICE:

Do not use parts cleaner when cleaning the rear speed sensor rotor RH.



Result:
Proceed to
NEXT



NEXT

6.READ VALUE USING GTS (RR WHEEL SPEED, MOMENTARY INTERRUPTION)
6.READ VALUE USING GTS (RR WHEEL SPEED, MOMENTARY INTERRUPTION)
a.

While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>DATA LIST / ACTIVE TEST

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
RR Wheel Speed Rear skid control sensor RH reading Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
RR Speed Open Rear skid control sensor RH open detection Normal / Under intermittent Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
-
Chassis > Brake/EPB > Data List
Tester Display
RR Wheel Speed
RR Speed Open
50003 435 15,103
OK:

The values change in accordance with the operation of the vehicle and there is no intermittent operation.


NOTICE:

Perform the above inspection before removing the sensor and connector.


HINT:
·

The rear speed sensor rotor RH is incorporated into the rear axle hub and bearing assembly RH.

·

If the rear speed sensor rotor RH needs to be replaced, replace it together with the rear axle hub and bearing assembly RH.




Result:
Proceed to
OK
NG



OK

END

NG

REPLACE REAR SKID CONTROL SENSOR RH AND REAR SPEED SENSOR ROTOR RH

7.CLEAN REAR SKID CONTROL SENSOR RH
a.

Clean the rear skid control sensor RH.

NOTICE:

When cleaning the rear skid control sensor RH, make sure to clean the installation hole before installation.



Result:
Proceed to
NEXT



NEXT

8.READ VALUE USING GTS (RR WHEEL SPEED, MOMENTARY INTERRUPTION)
8.READ VALUE USING GTS (RR WHEEL SPEED, MOMENTARY INTERRUPTION)
a.

While monitoring the values of the Data List, perform a road test and attempt to reproduce the problem symptoms based on the interview with the customer and the vehicle conditions stored as Freeze Frame Data when the DTC was stored.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for Gasoline Model)>DATA LIST / ACTIVE TEST

Chassis > Brake/EPB > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
RR Wheel Speed Rear skid control sensor RH reading Min.: 0.0 km/h (0 mph)
Max.: 6553.5 km/h (4072 mph)
Vehicle stopped: 0.0 km/h (0.0 mph) When driving at constant speed: No large fluctuations
RR Speed Open Rear skid control sensor RH open detection Normal / Under intermittent Normal: Momentary interruption not detected
Under intermittent: Momentary interruption detected
-
Chassis > Brake/EPB > Data List
Tester Display
RR Wheel Speed
RR Speed Open
50003 435 15,103
OK:

The values change in accordance with the operation of the vehicle and there is no intermittent operation.


NOTICE:

Perform the above inspection before removing the sensor and connector.



Result:
Proceed to
OK
NG



OK

END

NG

4.CHECK REAR SPEED SENSOR ROTOR RH (CHECK FOR FOREIGN MATTER)