When the drive mode select switch is operated, a switch signal is sent to the hybrid vehicle control ECU, then the hybrid vehicle control ECU changes the drive mode.
| Result | Proceed to |
|---|---|
| All of the ECUs and sensors that are currently connected to the CAN communication system are displayed | A |
| None of the ECUs and sensors that are currently connected to the CAN communication system are displayed, or some of them are not displayed | B |
A
B
| Result | Proceed to |
|---|---|
| No DTCs are output | A |
| DTCs are output | B |
A
B
Turn the ignition switch to ON.
Operate the drive mode select switch (No. 1 pattern select switch assembly) to change the drive mode.
Check that the drive mode indicator is displayed on the multi-information display and changes according to the selected drive mode.
| Result | Proceed to |
|---|---|
| Display changes according to drive mode select switch operation | A |
| Display does not change according to drive mode select switch operation | B |
Turn the ignition switch off.
A
B
Read the Data List using the GTS.
| Tester Display |
|---|
| Drive Mode Switch- |
| Drive Mode Switch+ |
| Result | Proceed to |
|---|---|
| GTS display changes according to drive mode select switch operation | A |
| Other than above | B |
Turn the ignition switch off.
A
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>COMBINATION SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the P3 drive mode select switch (No. 1 pattern select switch assembly) connector.
| *a | Front view of wire harness connector
(to Drive Mode Select Switch (No. 1 Pattern Select Switch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| P3-5 (E) - Body ground | Always | Below 1 Ω |
Reconnect the P3 drive mode select switch (No. 1 pattern select switch assembly) connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the H67 hybrid vehicle control ECU connector.
Disconnect the P3 drive mode select switch (No. 1 pattern select switch assembly) connector.
| *a | Front view of wire harness connector
(to Hybrid Vehicle Control ECU) |
| *b | Front view of wire harness connector
(to Drive Mode Select Switch (No. 1 Pattern Select Switch Assembly)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H67-37 (DMS-) - P3-6 (E) | Always | Below 1 Ω |
| H67-38 (DMS+) - P3-7 (SEL) | Always | Below 1 Ω |
| H67-37 (DMS-) or P3-6 (E) - Body ground | Always | 10 kΩ or higher |
| H67-38 (DMS+) or P3-7 (SEL) - Body ground | Always | 10 kΩ or higher |
Reconnect the P3 drive mode select switch (No. 1 pattern select switch assembly) connector.
Reconnect the H67 hybrid vehicle control ECU connector.
| Proceed to |
|---|
| OK |
| NG |
OK
NG