Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
42341C
1.INSTALL REAR DRIVE SHAFT SNAP RING
Install a new rear drive shaft snap ring.
Face the end gap of the rear drive shaft snap ring downward.
42340B
2.INSTALL REAR DRIVE SHAFT ASSEMBLY
Coat the rear drive shaft snap ring of the rear drive shaft inboard joint assembly with MP grease.
Coat the splines of the rear drive shaft inboard joint assembly with Toyota genuine differential gear oil LX.
Align the inboard joint splines, and using a brass bar and a hammer, install the rear drive shaft assembly.
Face the end gap of the rear drive shaft snap ring downward.
Do not damage the rear drive shaft oil seal or transmission coupling dust seal.
Do not damage the rear drive shaft inboard joint boot.
Make sure to center the rear drive shaft assembly during installation to prevent damage to the rear drive shaft snap ring.
Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.
| *a | Matchmark |
Align the matchmarks and install the rear drive shaft assembly to the rear axle hub and bearing assembly.
Do not damage the rear disc brake dust cover sub-assembly.
Do not damage the rear drive shaft outboard joint boot.
Check that there is no foreign matter on the contact surfaces.
Do not push the rear axle carrier sub-assembly towards the outside of the vehicle any further than necessary.
48790
3.TEMPORARILY INSTALL REAR UPPER CONTROL ARM ASSEMBLY
48720A
4.TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY
48740F
5.TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY
48258C
6.INSTALL REAR LOWER COIL SPRING INSULATOR
48231B
7.INSTALL REAR COIL SPRING
8.CONNECT REAR STABILIZER LINK ASSEMBLY
9.INSTALL REAR SKID CONTROL SENSOR
890C0A
10.CONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
42312B
11.INSTALL REAR AXLE SHAFT NUT
47319F
12.CONNECT REAR FLEXIBLE HOSE
13.STABILIZE SUSPENSION
48720A
14.INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY
48740F
15.INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY
48790
16.INSTALL REAR UPPER CONTROL ARM ASSEMBLY
48738
17.INSTALL REAR SUSPENSION ARM COVER
17430
18.INSTALL TAIL EXHAUST PIPE ASSEMBLY (for RH Side)
19.INSTALL REAR WHEEL
48740F
20.INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY
21.ADD DIFFERENTIAL OIL
for Dynamic Torque Control AWD: Click hereGeneral>MAINTENANCE>DIFFERENTIAL OIL>REPLACEMENT
for Dynamic Torque Vectoring AWD: Click hereGeneral>MAINTENANCE>DIFFERENTIAL OIL>REPLACEMENT
22.INSPECT FOR DIFFERENTIAL OIL LEAK
23.INSPECT FOR EXHAUST GAS LEAK (for RH Side)
24.INSPECT AND ADJUST REAR WHEEL ALIGNMENT
25.CHECK FOR SPEED SENSOR SIGNAL
26.PERFORM INITIALIZATION
Parking support brake system calibration:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING SUPPORT BRAKE SYSTEM>CALIBRATION
Parking assist monitor system calibration:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION
Panoramic view monitor system calibration:
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PANORAMIC VIEW MONITOR SYSTEM>CALIBRATION
SFI system initialization:
Click hereEngine / Hybrid System>2GR-FKS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION