Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR
RM37A0E _58 Vehicle Interior _086892 SUPPLEMENTAL RESTRAINT SYSTEMS _0421228 SIDE AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR  INSTALLATION  


PROCEDURE

Hide 89860A 1.INSTALL SIDE AIRBAG SENSOR ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



c.
B566198C01
1.49,0.99 0.542,0.99 true 0.375,0.885 0.688,1.042 0.313,0.156 10 false *a
*a Stopper


Insert the side airbag sensor assembly stopper into the door hole, engage the claw and install the side airbag sensor assembly to the front door panel with the nut.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the side airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

·

When installing the side airbag sensor assembly, make sure that the SRS wiring does not interfere with or is not pinched between other parts.

·

Make sure that the side airbag sensor assembly stopper is securely inserted into the door hole.

·

Keep the stud bolt and waterproof rubber seal free of foreign matter.




d.

Connect the connector to the side airbag sensor assembly.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.


HINT:

Refer to How to Connect or Disconnect Airbag Connector.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



e.

Check that there is no looseness in the installed parts of the side airbag sensor assembly.


Hide 67832 2.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 67869J 3.INSTALL FRONT DOOR WEATHERSTRIP CLIP

Hide 67602 4.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 81230N 5.INSTALL COURTESY LIGHT ASSEMBLY

Hide 6.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

Hide 7.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

Hide 69278B 8.INSTALL FRONT DOOR INSIDE HANDLE BEZEL

Hide 67492A 9.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 10.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

for 2GR-FKS: Click hereGeneral>MAINTENANCE>2GR-FKS BATTERY>INSTALLATION

for A25A-FXS, A25B-FXS: Click hereGeneral>MAINTENANCE>A25A-FXS, A25B-FXS AUXILIARY BATTERY>INSTALLATION

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 58441L 11.INSTALL BATTERY SERVICE HOLE COVER (for HV Model)