The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during starter assembly removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly or the radio receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
When the starter assembly is replaced, "ST relay" must also be replaced.
1.REMOVE BATTERY
53295E
2.REMOVE COOL AIR INTAKE DUCT SEAL
17750A
3.REMOVE INLET AIR CLEANER ASSEMBLY
17700
4.REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE
89661
5.REMOVE ECM
74404B
6.REMOVE BATTERY CLAMP SUB-ASSEMBLY
28100
7.REMOVE STARTER ASSEMBLY
Disconnect the 2 starter assembly connectors.
Disengage the wire harness clamp.
Open the terminal cap.
Remove the nut and disconnect the engine wire from the terminal 30.
Type A:
Remove the 2 bolts and starter assembly.
Type B:
Remove the 2 nuts.
Using an E8 "TORX" socket wrench, remove the 2 stud bolts and starter assembly.
Remove the wire harness clamp.