The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below.
89615
1.REMOVE KNOCK CONTROL SENSOR
82219A
2.REMOVE SENSOR WIRE
Disengage the 2 clamps and remove the bolt and sensor wire.
19500
3.REMOVE IGNITION COIL ASSEMBLY
29300
4.REMOVE VACUUM PUMP ASSEMBLY
16260
5.REMOVE WATER BY-PASS HOSE ASSEMBLY
Slide the clip and remove the water by-pass hose assembly from the water inlet pipe.
16267
6.REMOVE NO. 3 WATER BY-PASS HOSE
Slide the clip and remove the No. 3 water by-pass hose from the water inlet pipe.
16264
7.REMOVE NO. 2 WATER BY-PASS HOSE
Slide the clip and remove the No. 2 water by-pass hose from the water outlet.
12261
8.REMOVE VENTILATION HOSE
Slide the clip and remove the ventilation hose from the PCV valve (ventilation valve sub-assembly).
12262
9.REMOVE NO. 2 VENTILATION HOSE
Slide the clip and remove the No. 2 ventilation hose from the cylinder head cover sub-assembly.
16361A
10.REMOVE V-RIBBED BELT
27020
11.REMOVE GENERATOR ASSEMBLY
12.REMOVE COMPRESSOR AND MAGNETIC CLUTCH
88431
13.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET
Remove the 2 bolts and No. 1 compressor mounting bracket from the cylinder block sub-assembly.
16604
14.REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
16620
15.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
Remove the 2 bolts and V-ribbed belt tensioner assembly.
16173
16.REMOVE WATER PUMP PULLEY
11452
17.REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE
Remove the engine oil level dipstick from the engine oil level dipstick guide.
Remove the bolt and engine oil level dipstick guide from the camshaft housing sub-assembly LH and oil pan sub-assembly.
Remove the engine oil level dipstick guide O-ring from the engine oil level dipstick guide.
12585
18.REMOVE NO. 5 CYLINDER BLOCK INSULATOR
Remove the No. 5 cylinder block insulator from the engine assembly.
43457
19.REMOVE DRIVE SHAFT BEARING BRACKET
| *A | for 2WD |
| *B | for AWD |
Remove the 3 bolts and drive shaft bearing bracket from the cylinder block sub-assembly.
20.REMOVE WIRE HARNESS CLAMP BRACKET
Remove the bolt and wire harness clamp bracket from the camshaft housing sub-assembly LH.
Remove the bolt and wire harness clamp bracket from the camshaft housing sub-assembly.
16522
21.REMOVE WATER FILLER BRACKET
Remove the 2 bolts and water filler bracket from the camshaft housing sub-assembly LH.