This DTC is stored when an open circuit or short occurs in the communication line between the front center ultrasonic sensor RH and the front center ultrasonic sensor LH, or when a malfunction occurs in the front center ultrasonic sensor RH.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1AE387 | Ultrasonic Sensor (Front Right Center) Missing Message | Front center ultrasonic sensor RH lost communication | ·
Front center ultrasonic sensor RH ·
Harness or connector ·
Clearance warning ECU assembly |
Perform registration after replacing or removing and installing the ultrasonic sensor or clearance warning ECU assembly.
If a DTC is detected again after the repair, turn the ignition switch to ON and turn the TOYOTA parking assist-sensor system on, and then clear the DTC.
If C1AE296 is output at the same time, check C1AE296 first.
Register the TOYOTA parking assist-sensor system.
| Proceed to |
|---|
| NEXT |
NEXT
According to the display on the GTS, check for DTCs.
According to the display on the GTS, clear the DTCs.
Recheck for DTCs.
| Symptoms | DTC Detection | |||
|---|---|---|---|---|
| C1AE187 | C1AE287 | C1AE387 | C1AE487 | |
| Symptom 1 | Not output | Not output | Not output | Not output |
| Symptom 2 | Output | Output | Output | Output |
| Symptom 3 | Not output | Output | Output | Output |
| Symptom 4 | Not output | Not output | Output | Output |
| Symptom 5 | Not output | Not output | Not output | Output |
| Result | Proceed to |
|---|---|
| Listed under symptom 1 in combination table | A |
| Listed under symptom 2 in combination table | B |
| Listed under symptom 3 in combination table | C |
| Listed under symptom 4 in combination table | D |
| Listed under symptom 5 in combination table | E |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
D
E
Disconnect the B2 front center ultrasonic sensor LH connector.
Disconnect the B3 front center ultrasonic sensor RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B2-1 (BO) - B3-4 (BI) | Always | Below 1 Ω |
| B2-2 (SO) - B3-5 (SI) | Always | Below 1 Ω |
| B2-3 (EO) - B3-6 (EI) | Always | Below 1 Ω |
| B2-1 (BO) or B3-4 (BI) - Body ground | Always | 10 kΩ or higher |
| B2-2 (SO) or B3-5 (SI) - Body ground | Always | 10 kΩ or higher |
| B2-3 (EO) or B3-6 (EI) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the front center ultrasonic sensor RH.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
Inspect the front center ultrasonic sensor RH.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
Replace the front center ultrasonic sensor RH with a new or normally functioning one.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR (for Front)>REMOVAL
To check if the ultrasonic sensor is functioning correctly, replace it with another ultrasonic sensor.
| Proceed to |
|---|
| NEXT |
NEXT
According to the display on the GTS, check for DTCs.
According to the display on the GTS, clear the DTCs.
Recheck for DTCs.
| Result | Proceed to |
|---|---|
| No DTC is output | A |
| "C1AE387" is output | B |
A
B
for LHD: Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING ECU (for LHD)>REMOVAL
for RHD: Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>CLEARANCE WARNING ECU (for RHD)>REMOVAL