Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model) › from 2020.11
RM37A0E _54 Brake _086868 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0421002 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model) J

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(for HV Model)  Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)  


DESCRIPTION

Depending on the malfunction, the skid control ECU prohibits operation of the electronically controlled brake system to protect components and prevent incorrect operation when DTCs are stored.

If the switching solenoid is disabled due to prohibition of the electronically controlled brake system, the response of the brake pedal changes and braking performance is reduced.

CAUTION / NOTICE / HINT

NOTICE:

After replacing the No. 1 skid control ECU (brake booster with master cylinder assembly), perform "Calibration".

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (for HV Model)>UTILITY


PROCEDURE

1.BRAKE PROBLEM CHECK
a.

Check the conditions at the time the problem occurred.

i.

Whether a warning light illuminated or the buzzer sounded.


ii.

Road surface condition when the problem occurred and just before the problem occurred.


iii.

When the problem occurred and how many times the brake pedal was depressed before the problem occurred.


iv.

Frequency of the abnormal brake pedal response.



Result:
Proceed to
NEXT



NEXT

2.CHECK DTC AND FREEZE FRAME DATA
2.CHECK DTC AND FREEZE FRAME DATA
a.

Using the GTS, check DTCs and Freeze Frame Data.

Chassis > Brake Booster > Trouble Codes
50001 466
Chassis > Brake/EPB > Trouble Codes
50001 435
Result:
Result Proceed to
DTCs are not output. A
DTCs are output. B


HINT:
·

If there are currently no warnings and the brake pedal travel is not excessive, DTCs may have been cleared after the system returned to normal.

·

If the brake pedal response returned to normal and there are currently no warnings, the system is normal.





A

3.CHECK BRAKE PEDAL

B

3.CHECK BRAKE PEDAL
a.

While depressing the brake pedal by hand, check the installation condition of the brake pedal stroke sensor assembly and brake pedal, and check for mechanical malfunctions.



Result:
Proceed to
NEXT



NEXT

4.INSPECT BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY
4.INSPECT BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE SYSTEM (for HV Model)>ON-VEHICLE INSPECTION

OK:

The brake booster with master cylinder assembly is normal.


Result:
Proceed to
OK
NG



OK

NG

REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY