2014 Hilux · Service Manual BRAKE

C1203 ECM Communication Circuit Malfunction

Diagnostic trouble codes · Vehicles built Jun 2011 – Jul 2012

Versions by build date: Jun 2011 – Jul 2012 Aug 2012 – Jul 2013 from Aug 2013

DESCRIPTION

This circuit is used to send control information from the skid control ECU (brake actuator assembly) to the ECM and engine control information from the ECM to the skid control ECU (brake actuator assembly) through the CAN communication system.
DTC Code
DTC Detection Condition
Trouble Area
C1203
The engine, drivetrain and destination variations that are sent from the ECM do not match the ones of the skid control ECU.
ECM

INSPECTION PROCEDURE


1. CHECK PART NUMBER (ECM AND BRAKE ACTUATOR ASSEMBLY)
  1. Check that the proper ECM and brake actuator assembly are installed.

    Result 
    Result
    Proceed to
    Proper ECUs are installed
    A
    Proper ECUs are not installed
    B



B
REPLACE ECUS WITH PROPER ONES
A


2. RECONFIRM DTC
  1. Clear the DTC (Click here).

  1. Turn the ignition switch off.

  1. Check if the same DTC is output.

    HINT:
    Reinstall the sensors, connectors, etc. and restore the vehicle to its prior condition before rechecking for DTCs.

    Result 
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B

    HINT:
    Refer to the ECM removal procedures: 
    Item
    See page
    1KD-FTV
    except DPF
    Click here
    for DPF
    Click here
    2KD-FTV
    except DPF
    Click here
    for DPF
    Click here
    1GR-FE
    Click here



B
REPLACE ECM
A

USE SIMULATION METHOD TO CHECK (Click here)


← C1201 Engine Control System Malfunction (from Aug 2014)C1203 ECM Communication Circuit Malfunction (Aug 2012 – Jul 2013) →