2014 Hilux · Service Manual DRIVE LINE

REPLACEMENT

Removal / installation · Vehicles built Jun 2011 – Jul 2014

Versions by build date: Jun 2011 – Jul 2014 from Aug 2014


1. DRAIN TRANSFER OIL

2. REMOVE LOWER TRANSFER CASE PROTECTOR

  1. F043499
    Remove the 4 bolts and protector.


3. REMOVE REAR PROPELLER SHAFT ASSEMBLY
  1. TMT made:
    Remove the rear propeller shaft (Click here).

  1. TSAM made:
    Remove the rear propeller shaft (Click here).


4. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
  1. Remove the companion flange (rear) in the same way as the companion flange (front).

    SST
    09330-00021  
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011)


5. REMOVE TRANSFER EXTENSION HOUSING OIL SEAL

  1. F043484E01
    Using SST, tap out the oil seal.
    SST
    09308-00010  

    NOTICE:
    Be careful not to damage the oil seal and extension housing contact surface.


6. INSTALL TRANSFER EXTENSION HOUSING OIL SEAL
  1. Coat the lip of a new oil seal with MP grease.

  1. F043486E01
    Using SST and a hammer, tap in the oil seal until its surface is flush with the housing upper surface.
    SST
    09316-60011   (09316-00011)


7. INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
  1. Apply gear oil to the connecting areas of the companion flange and output shaft.

  1. Using SST, install the companion flange (rear) in the same way as the companion flange (front).

    SST
    09330-00021  
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011)

    Torque:
    118 N*m{ 1,203 kgf*cm , 87 ft.*lbf }


8. INSTALL REAR PROPELLER SHAFT ASSEMBLY
  1. TMT made:
    Install the rear propeller shaft (Click here).

  1. TSAM made:
    Install the rear propeller shaft (Click here).


9. INSTALL LOWER TRANSFER CASE PROTECTOR

  1. F043499
    Install the protector with the 4 bolts.

    Torque:
    18 N*m{ 183 kgf*cm , 13 ft.*lbf }


10. ADD TRANSFER OIL
  1. Remove the case plug (for filler) and gasket.

  1. Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the case plug (for filler) hole.

    NOTICE:
    1. When adding oil, pour it slowly.
    2. Add oil a little at a time, waiting several minutes between each addition of oil.

  1. Wait approximately 5 minutes and check that the oil level has not changed.

  1. Install a new gasket and the case plug (for filler).

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

← COMPONENTS (from Jun 2011)REPLACEMENT (from Aug 2014) →