2014 Hilux · Service Manual DRIVE LINE

REPLACEMENT

Removal / installation · Vehicles built from Aug 2014

Versions by build date: Jun 2011 – Jul 2014 from Aug 2014


1. DRAIN TRANSFER OIL

2. REMOVE LOWER TRANSFER CASE PROTECTOR

  1. F043499
    Remove the 4 bolts and protector.


3. REMOVE REAR PROPELLER SHAFT ASSEMBLY
for TMT made: (Click here)
for TSAM made: (Click here)

4. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
  1. Remove the companion flange (rear) in the same way as the companion flange (front).

    SST
    09330-00021  
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011)


5. REMOVE TRANSFER EXTENSION HOUSING OIL SEAL

  1. F043484E01
    Using SST, tap out the oil seal.
    SST
    09308-00010  

    NOTICE:
    Be careful not to damage the oil seal and extension housing contact surface.


6. INSTALL TRANSFER EXTENSION HOUSING OIL SEAL
  1. Coat the lip of a new oil seal with MP grease.

  1. F043486E01
    Using SST and a hammer, tap in the oil seal until its surface is flush with the housing upper surface.
    SST
    09316-60011   (09316-00011)


7. INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
  1. Apply gear oil to the connecting areas of the companion flange and output shaft.

  1. Using SST, install the companion flange (rear) in the same way as the companion flange (front).

    SST
    09330-00021  
    09950-40011   (09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04051, 09957-04010, 09958-04011)

    Torque:
    118 N*m{ 1,203 kgf*cm , 87 ft.*lbf }


8. INSTALL REAR PROPELLER SHAFT ASSEMBLY
for TMT made: (Click here)
for TSAM made: (Click here)

9. INSTALL LOWER TRANSFER CASE PROTECTOR

  1. F043499
    Install the protector with the 4 bolts.

    Torque:
    18 N*m{ 183 kgf*cm , 13 ft.*lbf }


10. ADD TRANSFER OIL
(Click here)
← REPLACEMENT (Jun 2011 – Jul 2014)PROBLEM SYMPTOMS TABLE (from Jun 2011) →