1.INSPECT BRAKE PEDAL AND PARKING BRAKE
2.INSPECT BRAKE LINE PIPES AND HOSES
Work in a well-lighted area. Turn the front wheels fully to the right or left before beginning the inspection.
Using a mirror, check the entire circumference and length of the brake lines and hoses for:
Damage
Wear
Deformation
Cracks
Corrosion
Leaks
Bends
Twists
Check all the clamps for tightness and the connections for leakage.
Check that the hoses and lines are not near sharp edges, moving parts or the exhaust system.
Check that the lines are installed properly and pass through the center of the grommets.
3.INSPECT BRAKE PADS AND DISCS
Check the front brake pads and discs (See page Brake>BRAKE (FRONT)>FRONT BRAKE(for 4WD and Pre-Runner)>INSPECTION).
If a squealing or scraping noise is heard from the brake while driving, check the pad wear indicator.
If there are traces of the indicator contacting the disc rotor, the disc pad should be replaced.
4.INSPECT BRAKE LININGS AND DRUMS
Check the rear brake linings and drums (See page Brake>BRAKE (REAR)>REAR BRAKE(for 4WD and Pre-Runner)>INSPECTION).
7.INSPECT VACUUM PUMP (for 1KD-FTV, 2KD-FTV)
Inspect the vacuum pump (See page Brake>BRAKE SYSTEM (OTHER)>VACUUM PUMP(for 1KD-FTV, 2KD-FTV)>ON-VEHICLE INSPECTION).
8.INSPECT CLUTCH FLUID
Inspect the clutch fluid (See page Drivetrain>CLUTCH>CLUTCH SYSTEM>BLEEDING).