When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.
When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.
After removing the injection pipes, clean them with a brush and compressed air.
1.REMOVE NO. 1 TIMING BELT COVER
2.REMOVE TIMING BELT
3.REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY
4.REMOVE CRANKSHAFT PULLEY
5.REMOVE NO. 2 INTERCOOLER SUPPORT BRACKET
Remove the 2 bolts and No. 2 intercooler support bracket.
6.REMOVE INTERCOOLER SUPPORT BRACKET
Remove the 2 bolts and intercooler support bracket.
7.REMOVE VENTILATION PIPE
8.REMOVE COMPRESSOR INLET ELBOW
9.REMOVE NO. 1 TURBO INSULATOR
10.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
11.REMOVE NO. 1 TURBO WATER HOSE
12.REMOVE TURBINE OUTLET ELBOW
13.REMOVE TURBOCHARGER STAY
14.DISCONNECT TURBO OIL INLET PIPE SUB-ASSEMBLY
15.REMOVE EXHAUST MANIFOLD WITH TURBOCHARGER
Remove the 8 nuts, 8 plate washers, 8 collars and exhaust manifold with turbocharger shown in the illustration.
16.REMOVE NO. 2 IDLE PULLEY ASSEMBLY
17.REMOVE GENERATOR ASSEMBLY
18.REMOVE GENERATOR BRACKET
Remove the bolt and generator bracket.
19.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
Remove the 4 bolts and V-ribbed belt tensioner.
20.REMOVE NO. 1 COMPRESSOR MOUNTING BRACKET (w/ Air Conditioning System)
Remove the 4 bolts and No. 1 compressor mounting bracket.
21.REMOVE WATER INLET
22.REMOVE THERMOSTAT
23.REMOVE WATER OUTLET
Remove the 2 bolts, water outlet and gasket.
24.REMOVE DIESEL THROTTLE BODY ASSEMBLY
25.REMOVE INTAKE MANIFOLD
26.REMOVE GLOW PLUG ASSEMBLY
27.REMOVE OIL FILTER SUB-ASSEMBLY
28.REMOVE FUEL INLET PIPE SUB-ASSEMBLY
29.REMOVE COMMON RAIL ASSEMBLY
30.REMOVE FUEL SUPPLY PUMP ASSEMBLY
31.REMOVE OIL COOLER COVER SUB-ASSEMBLY
32.REMOVE TIMING GEAR COVER INSULATOR (w/ EGR Cooler)
Remove the bolt and timing gear cover insulator.
33.REMOVE VACUUM PUMP ASSEMBLY
Remove the 2 nuts, vacuum pump and 2 O-rings.
34.REMOVE VANE PUMP ASSEMBLY
Remove the 2 nuts, vane pump and O-ring.
35.REMOVE CRANKSHAFT POSITION SENSOR
36.REMOVE CAMSHAFT POSITION SENSOR
37.REMOVE ENGINE COOLANT TEMPERATURE SENSOR
38.REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET RH
| *A | RH Side |
| *B | LH Side |
Remove the 4 bolts and front No. 1 engine mounting bracket.
39.REMOVE FRONT NO. 1 ENGINE MOUNTING BRACKET LH
Remove the 4 bolts and front No. 1 engine mounting bracket.