Home › Engine / Hybrid System › 2KD-FTV COOLING › WATER PUMP(w/o DPF) › from 2012.10
RM1840EF _51 Engine / Hybrid System _009595 2KD-FTV COOLING _0052372 WATER PUMP(w/o DPF) A

2KD-FTV COOLING  WATER PUMP(w/o DPF)  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injectors (including shuffling the injectors between the cylinders), common rail or cylinder head, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump, common rail, cylinder block, cylinder head, cylinder head gasket or timing gear case, it is necessary to replace the fuel inlet pipe with a new one.

·

After removing the injection pipes, clean them with a brush and compressed air.



PROCEDURE

Hide 1.INSTALL ENGINE WATER PUMP ASSEMBLY

a.

Install a new gasket and the engine water pump with the 5 bolts and 2 nuts.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)


Hide 9.INSTALL NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY

Hide 15.INSTALL FAN SHROUD

a.

Install the fan pulley to the engine water pump.


b.

Install the fan shroud together with the fluid coupling with fan between the radiator and engine component.

NOTICE:

Be careful not to damage the radiator core.



c.

Install the fluid coupling with fan to the fan pulley with the 4 nuts.

Tighten the nuts as much as possible by hand.


d.
A110385

Attach the claws of the fan shroud to the radiator.


e.

Install the fan shroud with the 2 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


f.

Install the fan and generator V belt (See page Engine / Hybrid System>2KD-FTV ENGINE MECHANICAL>DRIVE BELT>INSTALLATION).


g.

Tighten the 4 nuts of the fluid coupling with fan.

Torque:
23 N*m (235 kgf*cm, 17 ft.*lbf)


h.

Install the radiator reservoir with the 2 bolts.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


i.

Connect the No. 1 and No. 2 water by-pass hoses to the radiator.


j.

Install the oil reservoir with the 3 bolts.

Torque:
4.5 N*m (46 kgf*cm, 40 in.*lbf)


Hide 16.INSTALL RADIATOR HOSE INLET

Hide 17.INSTALL ELECTRIC EGR CONTROL VALVE ASSEMBLY WITH NO. 2 EGR VALVE AND EGR COOLER (w/ EGR Cooler)

Hide 18.INSTALL INTERCOOLER ASSEMBLY (w/ EGR Cooler)

Hide 19.INSTALL NO. 2 AIR CLEANER PIPE SUB-ASSEMBLY (w/o EGR Cooler)

Hide 20.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 26.INSTALL NO. 1 ENGINE UNDER COVER (for 4WD and Pre-Runner)