Home › Engine / Hybrid System › 1GR-FE COOLING › WATER PUMP › from 2012.10
RM1840EF _51 Engine / Hybrid System _009597 1GR-FE COOLING _0052383 WATER PUMP A

1GR-FE COOLING  WATER PUMP  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE ENGINE SIDE COVER SUB-ASSEMBLY LH

Hide 4.REMOVE ENGINE SIDE COVER SUB-ASSEMBLY RH

Hide 5.REMOVE NO. 1 ENGINE UNDER COVER

Hide 9.DISCONNECT RADIATOR HOSE INLET

a.

Disconnect the radiator hose inlet from the radiator.


Hide 10.DISCONNECT RADIATOR HOSE OUTLET

a.

Disconnect the radiator hose outlet from the radiator.


Hide 13.REMOVE WATER INLET ASSEMBLY

a.
A076335

Remove the 2 radiator hoses from the water inlet assembly.


b.
A076336

Disconnect the 5 water by-pass hoses.


c.
A076337

Remove the 5 bolts and water inlet assembly.


d.

Remove the O-ring from the water outlet pipe.


e.

Remove the gasket from the engine water pump.


Hide 14.REMOVE NO. 2 IDLER PULLEY

a.
A076338

w/ Idler Pulley Cover Plate:

i.

Remove the 2 bolts, 2 idler pulley cover plates, 2 No. 2 idler pulleys and 2 No. 2 idler pulley cover plates.



b.

w/o Idler Pulley Cover Plate:

i.

Remove the 2 bolts, 2 No. 2 idler pulleys and 2 No. 2 idler pulley cover plates.



c.

for Integrated Type:

i.

Remove the 2 bolts and 2 No. 2 idler pulleys.



Hide 16.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

Hide 17.REMOVE ENGINE WATER PUMP ASSEMBLY

a.
A072954

Remove the 17 bolts, engine water pump assembly and gasket.