1.DRAIN TRANSFER OIL
2.REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
3.REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
4.REMOVE EXTENSION HOUSING OIL SEAL
Using SST, tap out the oil seal.
Be careful not to damage the oil seal and extension housing contact surface.
5.INSTALL EXTENSION HOUSING OIL SEAL
Coat the lip of a new oil seal with MP grease.
Using SST and a hammer, tap in the oil seal until its surface is flush with the housing upper surface.
6.INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY
7.INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
8.ADD TRANSFER OIL