Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
1.INSTALL FRONT DRIVE SHAFT HOLE SNAP RING
Install a new hole snap ring.
2.INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
Coat the splines of the inboard joint with differential oil.
Align the splines and tap in the drive shaft with a brass bar and hammer.
Whether or not the inboard joint shaft is in contact with the pinion shaft can be determined from the sound and feeling when tapping in the shaft.
Make sure that the snap ring opening is facing downwards when installing the drive shaft.
Be careful not to damage the oil seal, boot or dust cover.
3.CONNECT FRONT SPEED SENSOR (w/ ABS)
4.CONNECT FRONT LOWER SUSPENSION ARM ASSEMBLY LH
5.CONNECT TIE ROD END SUB-ASSEMBLY LH
6.INSTALL FRONT AXLE SHAFT NUT
7.INSTALL FRONT AXLE HUB GREASE CAP
8.INSTALL FRONT WHEEL
9.ADD DIFFERENTIAL OIL
10.INSTALL NO. 2 ENGINE UNDER COVER
11.INSTALL NO. 1 ENGINE UNDER COVER
12.CHECK ABS SPEED SENSOR SIGNAL (w/ ABS)