Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR DIFFERENTIAL CARRIER ASSEMBLY(for DANA Made)
RM1840EF _52 Drivetrain _009618 AXLE AND DIFFERENTIAL _0052568 REAR DIFFERENTIAL CARRIER ASSEMBLY(for DANA Made) A

AXLE AND DIFFERENTIAL  REAR DIFFERENTIAL CARRIER ASSEMBLY(for DANA Made)  INSTALLATION  


PROCEDURE

Hide 1.INSTALL REAR DIFFERENTIAL CARRIER ASSEMBLY

a.

Clean the contact surfaces of the differential carrier and axle housing.

NOTICE:

Be careful not to damage the installation surface.



b.

Install the differential carrier and a new gasket with the 10 nuts and washers.

Torque:
25 N*m (255 kgf*cm, 18 ft.*lbf)

NOTICE:

Be careful to install the gasket without tearing it.



Hide 2.INSTALL REAR AXLE SHAFT LH OIL SEAL

Hide 3.INSTALL REAR AXLE SHAFT RH OIL SEAL

HINT:

Use the same procedure described for the LH side.


Hide 4.INSTALL REAR AXLE SHAFT WITH BACKING PLATE LH

Hide 5.INSTALL REAR AXLE SHAFT WITH BACKING PLATE RH

HINT:

Use the same procedure described for the LH side.


Hide 9.INSTALL PARKING BRAKE SHOE LH

Hide 10.INSTALL PARKING BRAKE SHOE RH

HINT:

Use the same procedure described for the LH side.


Hide 11.INSTALL REAR BRAKE SHOE RETURN SPRING LH

Hide 12.INSTALL REAR BRAKE SHOE RETURN SPRING RH

HINT:

Use the same procedure described for the LH side.


Hide 13.CHECK PARKING BRAKE INSTALLATION

Hide 14.BLEED AIR FROM BRAKE LINE

a.

Hide 15.CHECK FLUID LEVEL IN RESERVOIR

a.

Check the fluid level in the reservoir (See page Brake>BRAKE SYSTEM (OTHER)>BRAKE FLUID(for TASA Made)>ON-VEHICLE INSPECTION).


Hide 16.CHECK FOR BRAKE FLUID LEAKAGE

a.

Check for brake fluid leakage.


Hide 18.CHECK FOR DIFFERENTIAL OIL LEAKAGE

a.

Inspect and adjust the differential oil (See page Drivetrain>AXLE AND DIFFERENTIAL>DIFFERENTIAL OIL>REPLACEMENT).


Hide 19.INSTALL REAR PROPELLER SHAFT ASSEMBLY

Hide 21.ADJUST PARKING BRAKE