1.INSTALL FUEL FILLER OPENING LID LOCK RETAINER
Install the fuel filler opening lid lock retainer and turn it counterclockwise as shown in the illustration.
2.INSTALL FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
Install the fuel lid lock control cable and turn the fuel filler opening lid lock retainer clockwise as shown in the illustration.
Attach the cable to the clamps shown in the illustration.
Install the grommet to the vehicle body.
Install the fuel lid lock open lever.
| *1 | Fuel Lid Lock Open Lever | *2 | Grommet |
3.INSTALL REAR WHEEL HOUSE LINER LH
Install the rear wheel house liner.
4.INSTALL REAR NO. 1 WHEEL OPENING EXTENSION SUB-ASSEMBLY LH (w/ Over Fender)
5.INSTALL FRONT FLOOR CARPET ASSEMBLY
Install the front floor carpet.
6.INSTALL QUARTER INSIDE TRIM BOARD LH
Attach the 7 clips, 3 guides and 4 claws to install the quarter inside trim board.
Install the front door opening trim.
Connect the front seat outer belt floor anchor with the bolt.
7.INSTALL COWL SIDE TRIM BOARD LH
Attach the 2 clips to install the cowl side trim board.
Install the clip.
Install the front door opening trim.
8.INSTALL FRONT DOOR SCUFF PLATE LH
9.INSTALL LOWER BACK PANEL GARNISH
10.INSTALL REAR SEATBACK ASSEMBLY
11.INSTALL UPPER BACK PANEL GARNISH
12.INSTALL REAR SEAT CUSHION ASSEMBLY LH (w/ Seat Cushion)
13.INSTALL REAR SEAT CUSHION ASSEMBLY RH (w/ Seat Cushion)
14.INSTALL CONSOLE BOX ASSEMBLY
15.INSTALL FRONT SEAT ASSEMBLY LH
16.INSTALL FRONT SEAT ASSEMBLY RH
Use the same procedure described for the RH side.