Home › ENGINE · 2TR-FBE › FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. INSPECT FUEL INJECTOR ASSEMBLY
  1. Measure the resistance between the terminals.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    11.6 to 12.4 Ω

    If the result is not as specified, replace the fuel injector assembly.



2. INSPECT INJECTION VOLUME AND LEAKAGE


  1. Check the injection volume.

    CAUTION:
    This test involves high-pressure fuel and electricity, therefore, safety precautions should be taken. Perform this test in a safe area and avoid any sparks and flames. Do not smoke.


    1. Discharge the fuel system pressure (Click here).

    2. Remove the fuel hose from the fuel pressure pulsation damper (Click here).

    3. Remove the fuel hose from the fuel filter (Click here).

    4. Disconnect the fuel pressure regulator (Click here).

      NOTICE:
      Do not disconnect the No. 2 fuel hose from the fuel pressure regulator.



    5. Assemble SST as shown in the illustration.


      A111060E03

      SST
      09268-31012   (09268-41091, 09268-41120, 09268-41500, 95336-08070, 90467-13001)



    6. A237740E01
    7. Connect SST to the fuel filter.



    8. A237741E02
    9. Connect SST to the pressure regulator fuel inlet with the 2 bolts.

      Torque:
      8.5 N*m{ 87 kgf*cm , 75 in.*lbf }

      NOTICE:
      Make sure that the O-ring is installed to the pressure regulator.

    10. Install the O-ring to the fuel injector.



    11. A111061E05
    12. Assemble SST as shown in the illustration.

      SST
      09268-31012   (09268-41110, 09268-41310, 95336-08070, 90467-13001)

    13. Put the injector into a graduated cylinder.

      CAUTION:
      Install a suitable vinyl tube onto the injector to contain the gasoline spray.

    14. Operate the fuel pump.



    15. A099420E01
    16. Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with a graduated cylinder. Test each injector 2 or 3 times.

      SST
      09842-30080  

      Standard injection volume:
      95 to 115 cm3 (5.8 to 7.0 cu. in.) in 5 seconds

      Difference between each injector:
      20 cm3 (1.2 cu. in.) or less

      If the result is not as specified, replace the fuel injector.

  1. Check the fuel leakage.

    1. In the condition above, disconnect the test probes of SST (wire) from the battery and check the fuel leakage from the injector.

      Fuel leakage:
      1 drop or less per 12 minutes