Home › TRANSMISSION ยท R150 / R151 MANUAL TRANSMISSION › MANUAL TRANSMISSION ASSEMBLY

MANUAL TRANSMISSION ASSEMBLY > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here)



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE CONSOLE BOX ASSEMBLY
(Click here)


4. REMOVE SHIFT LEVER BOOT ASSEMBLY


G034215E05
  1. Remove the 4 screws, 2 clips and shift lever boot.



5. REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY


G021695E07
  1. Cover the shift lever cap with a cloth.

  1. Press down on the shift lever cap and rotate it counterclockwise to remove it.

  1. Pull out the shift lever.



6. REMOVE NO. 1 ENGINE UNDER COVER


7. REMOVE NO. 2 ENGINE UNDER COVER


8. DRAIN MANUAL TRANSMISSION OIL
  1. Remove the drain plug and gasket to drain the oil.

  1. Install a new gasket and the drain plug.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }



9. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
for DANA made: (Click here)
except DANA made: (Click here)


10. REMOVE FRONT EXHAUST PIPE ASSEMBLY
for 2KD-FTV: (Click here)
for 2TR-FE: (Click here)
for 2TR-FBE: (Click here)


11. DISCONNECT WIRE HARNESS
  1. Disconnect the back-up light switch connector and speedometer sensor connector.



12. DISCONNECT CLUTCH RELEASE CYLINDER ASSEMBLY


G034217E01
  1. Remove the 2 bolts and disconnect the release cylinder.



13. REMOVE STARTER ASSEMBLY
for 2KD-FTV (Click here)
for 2TR-FBE: (Click here)
for 2TR-FE: (Click here)


14. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY


B085193E09
  1. Support the transmission rear side with a support stand.

  1. Remove the 4 set bolts of the rear No. 1 engine mounting insulator.

  1. Remove the 4 bolts, 4 nuts and frame crossmember.



15. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR


G034219E06
  1. Remove the 4 bolts and mounting insulator.



16. REMOVE MANIFOLD STAY (for TR Series Engine)


B086194E01
  1. Remove the 3 bolts and exhaust manifold stay.



17. REMOVE STIFFENER PLATE (for 2KD-FTV)


    G034607E08
  1. Remove the 4 bolts and stiffener plate RH.

  1. Remove the 4 bolts and stiffener plate LH.



18. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY
  1. Using a transmission jack, support the transmission.

  1. Remove the support stand from the rear side.



    C238790E05
  1. for TR series Engine:
    Remove the 7 bolts and transmission.

  1. for 2KD-FTV:
    Remove the 5 bolts and transmission.