The manual transmission assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the transmission jack may suddenly drop or a part may fall.
36100
1.INSTALL TRANSFER ASSEMBLY
2.INSTALL WIRE HARNESS CLAMP BRACKET
Install the wire harness clamp bracket to the manual transmission unit assembly with the bolt.
33019C
3.INSTALL TRANSMISSION BREATHER SUB-ASSEMBLY
Connect the 3 clamps and install the transmission breather sub-assembly.
33030
4.INSTALL MANUAL TRANSMISSION UNIT ASSEMBLY
The manual transmission unit assembly is very heavy. Be sure to follow the procedure described in the repair manual, or the transmission jack may suddenly drop or a part may fall.
Make sure that the knock pins are not loose, bent, damaged or scratched.
Operate the transmission jack and install the manual transmission unit assembly to the vehicle.
Do not raise the manual transmission unit assembly more than necessary. If the manual transmission unit assembly is raised excessively, the vehicle may also be lifted up.
Make sure that the manual transmission unit assembly is clear of all wiring and hoses.
Align the input shaft with the clutch disc and install the manual transmission unit assembly to the engine.
| *1 | Transmission Breather Bracket |
Install the transmission breather bracket and 7 bolts.
12371A
5.INSTALL REAR ENGINE MOUNTING INSULATOR
Install the rear engine mounting insulator with the 4 bolts.
51204
6.INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
Install the No. 3 frame crossmember sub-assembly with the 4 bolts and 4 nuts.
Connect the No. 3 frame crossmember sub-assembly to the rear engine mounting insulator.
28100
7.INSTALL STARTER ASSEMBLY
8.CONNECT GROUND CABLE
Connect the ground cable with the bolt.
9.CONNECT WIRE HARNESS
Connect the 6 clamps and 2 connector.
17118
10.INSTALL MANIFOLD STAY
17410
11.INSTALL FRONT EXHAUST PIPE ASSEMBLY
37100
12.INSTALL PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY
37140
13.INSTALL FRONT PROPELLER SHAFT ASSEMBLY
51407A
14.INSTALL NO. 3 ENGINE UNDER COVER SUB-ASSEMBLY
51442
15.INSTALL NO. 2 ENGINE UNDER COVER
51410
16.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
17.ADD MANUAL TRANSMISSION OIL
33530F
18.INSTALL FLOOR SHIFT LEVER ASSEMBLY
|
MP grease |
Apply MP grease to the tip of the shift lever.
| *a | Press down |
| *b | Clockwise |
| *c | Lock |
Cover the shift lever cap with a cloth.
While pressing down on the shift lever cap, turn it clockwise to install the shift lever.
Attach the shift lever cap boot.
58280A
19.INSTALL SHIFT LEVER BOOT ASSEMBLY
Install the shift lever boot assembly with the 6 screws and 4 clips.
58810J
20.INSTALL CONSOLE BOX ASSEMBLY
21.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION