1.REMOVE FRONT SEAT ASSEMBLY RH
for Manual Seat:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>REMOVAL
for Power Seat:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>REMOVAL
2.REMOVE FRONT SEAT ASSEMBLY LH
for Manual Seat:
The procedure described below is for the RH side.
for Power Seat:
The procedure described below is for the RH side.
3.REMOVE REAR NO. 2 SEAT ASSEMBLY RH
4.REMOVE REAR NO. 2 SEAT ASSEMBLY LH
The procedure described below is for the RH side.
67914B
5.REMOVE FRONT DOOR SCUFF PLATE LH
67913B
6.REMOVE FRONT DOOR SCUFF PLATE RH
62111C
7.REMOVE COWL SIDE TRIM BOARD RH
67918E
8.REMOVE REAR DOOR SCUFF PLATE LH
73233
9.REMOVE OUTER LAP BELT ANCHOR COVER
62414A
10.REMOVE LOWER CENTER PILLAR GARNISH LH
67935
11.REMOVE BACK DOOR SCUFF PLATE
73233A
12.REMOVE REAR NO. 1 SEAT OUTER LAP BELT ANCHOR COVER
73233B
13.REMOVE REAR NO. 2 SEAT OUTER LAP BELT ANCHOR COVER
62512
14.REMOVE QUARTER INSIDE TRIM BOARD LH
58510D
15.REMOVE FRONT FLOOR CARPET ASSEMBLY
Partially remove the floor carpet.
It is not necessary to fully remove the floor carpet. Partially remove it so that the fuel lid lock control cable sub-assembly can be removed in a later step.
77306
16.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
Detach the claw and remove the fuel lid lock open lever sub-assembly.
77035
17.REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
Detach each clamp as shown in the illustration.
| *A | for 4WD without VSC | - | - |
| *1 | Fuel Lid Lock Control Cable Sub-assembly | - | - |
|
Remove in this Direction |
Detach the claw and remove the fuel lid lock control cable sub-assembly from the fuel filler opening lid lock retainer as shown in the illustration.
77377
18.REMOVE FUEL FILLER OPENING LID LOCK RETAINER
| *a | 90° |
|
Remove in this Direction (1) |
|
Remove in this Direction (2) |
|
Remove in this Direction (3) |
Remove the fuel filler opening lid lock retainer as shown in the illustration.