If a door glass or a power window regulator motor assembly does not operate smoothly, the catch protection function may be triggered automatically, resulting in the auto down operation being unable to fully open the window.
If a power window regulator motor assembly has been replaced with a new one, initialize the power window control system.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
When a door window regulator sub-assembly, power window regulator motor assembly, door glass or door glass run is reinstalled or replaced, the power window control system must be initialized. Functions such as the auto up and down function, jam protection function, catch protection function, remote control function and key-off operation function will not operate if initialization is not performed.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
This symptom may occur for any of the windows.
Initialize the power window regulator motor assembly (applicable location).
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Check that each power window moves when the auto up and down function of the power window regulator master switch assembly, power window regulator switch assembly, rear power window regulator switch assembly LH or rear power window regulator switch assembly RH is operated.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
Auto up and down function is normal (applicable location).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the door window regulator.
for Front Door:
Click hereVehicle Exterior>DOOR / HATCH>FRONT DOOR>DISASSEMBLY
for Rear Door:
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>DISASSEMBLY
Install the window glass to the door glass run.
for Front Door:
Click hereVehicle Exterior>DOOR / HATCH>FRONT DOOR>REASSEMBLY
for Rear Door:
Click hereVehicle Exterior>DOOR / HATCH>REAR DOOR>REASSEMBLY
Check if the door window regulator operates smoothly.
Check that the window glass slides smoothly when sliding it up by hand.
Perform initialization again.
The window glass fits with the glass run without improper contact or deformation.
Foreign matter is not caught in the glass run.
The glass run is not misaligned.
The belt moulding or inner weatherstrip is not caught.
The glass is not tilted and does not catch.
Door window glass slides smoothly.
| Result | Proceed to |
|---|---|
| OK (Driver door power window) (for LHD) | A |
| OK (Driver door power window) (for RHD) | B |
| OK (Front passenger door power window) (for LHD) | B |
| OK (Front passenger door power window) (for RHD) | A |
| OK (Rear LH door power window) | C |
| OK (Rear RH door power window) | D |
| NG | E |
A
B
C
D
E