Home › Engine / Hybrid System › 2TR-FBE ENGINE CONTROL › SFI SYSTEM › from 2016.07
RM33K0E _51 Engine / Hybrid System _054512 2TR-FBE ENGINE CONTROL _0269966 SFI SYSTEM T

2TR-FBE ENGINE CONTROL  SFI SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



SFI System
Symptom Suspected Area Link
Engine does not crank (Does not start) Battery Click here
Starter assembly Click here
Park/neutral position switch assembly (for Automatic Transmission Models) Click here
Clutch start switch assembly (for Manual Transmission Models) Click here
VC output circuit (ECM 5 V circuit) Click here
Starter signal circuit Click here
ECM power source circuit Click here
No initial combustion (Does not start) Immobiliser system Click here
VC output circuit (ECM 5 V output) Click here
ECM power source circuit Click here
Crankshaft position sensor Click here
Camshaft position sensor (for Intake Side) Click here
Camshaft position sensor (for Exhaust Side) Click here
Valve timing Click here
Ignition system Click here
Fuel pump control circuit Click here
Fuel injector circuit Click here
Starter signal circuit Click here
No. 1 valve rocker arm sub-assembly* -
Engine cranks normally but difficult to start Engine difficult to start Click here
Glow control system No. 1 Click here
Glow control system No. 2 Click here
Front door courtesy light switch assembly LH Click here
Fuel pump control circuit Click here
Engine coolant temperature sensor Click here
Ignition system Click here
Compression Click here
Fuel injector assembly Click here
Fuel injector circuit Click here
Intake system Click here
Throttle body with motor assembly Click here
PCV valve and hose Click here
Starter signal circuit Click here
ECM power source circuit Click here
No. 1 valve rocker arm sub-assembly* -
Incomplete intermittent combustion occurs (Does not start) Fuel pump control circuit Click here
Fuel suction with pump and gauge tube assembly (fuel pump) Click here
Fuel line -
Ignition system Click here
Fuel injector circuit Click here
ECM power source circuit Click here
Starter signal circuit Click here
Crankshaft position sensor Click here
Camshaft position sensor (for Intake Side) Click here
Camshaft position sensor (for Exhaust Side) Click here
Valve timing Click here
High engine speed Throttle body with motor assembly Click here
Intake system Click here
A/C signal circuit Click here
ECM power source circuit Click here
Engine coolant temperature sensor Click here
PCV valve and hose Click here
Low engine speed (Poor idle) Throttle body with motor assembly Click here
A/C signal circuit Click here
Fuel pump control circuit Click here
Fuel suction with pump and gauge tube assembly (fuel pump) Click here
Intake system Click here
PCV valve and hose Click here
Engine stalls on deceleration Engine stalls Click here
Idle speed (refer to "Low engine speed" symptom) -
Rough idle Rough idling Click here
Compression Click here
Ignition system Click here
Spark plug Click here
Fuel injector circuit Click here
ECM power source circuit Click here
Fuel pump control circuit Click here
Fuel suction with pump and gauge tube assembly (fuel pump) Click here
Fuel line -
Throttle body with motor assembly Click here
Intake system Click here
Purge VSV Click here
PCV valve and hose Click here
Air fuel ratio sensor Click here
Heated oxygen sensor Click here
Intake mass air flow meter sub-assembly Click here
Knock control sensor Click here
No. 1 valve rocker arm sub-assembly* -
External part malfunction (Increase in load: A/C system, etc.) -
Hunting (Poor idle) Electronic throttle control system Click here
Intake system Click here
ECM power source circuit Click here
Hesitation and/or poor acceleration (Poor driveability) Fuel pump control circuit Click here
Spark plug Click here
Ignition system Click here
Fuel injector assembly Click here
Intake mass air flow meter sub-assembly Click here
Electronic throttle control system Click here
Intake system Click here
Compression Click here
Brake override system Click here
No. 1 valve rocker arm sub-assembly* -
Surging (Poor driveability) Spark plug Click here
Fuel pump control circuit Click here
Ignition system Click here
Fuel injector assembly Click here
Intake mass air flow meter sub-assembly Click here
Variable Valve Timing (VVT) system Click here
Compression Click here
No. 1 valve rocker arm sub-assembly* -
Engine stalls soon after starting Immobiliser system Click here
Fuel pump control circuit Click here
Spark plug Click here
Ignition system Click here
Fuel injector assembly Click here
Variable Valve Timing (VVT) system Click here
Electronic throttle control system Click here
Intake system Click here
PCV valve and hose Click here
Compression Click here
No. 1 valve rocker arm sub-assembly* -
Lack of power Lack of power Click here
Brake override system Click here
Engine stalls only during A/C operation A/C signal circuit Click here
ECM Click here
MIL (malfunction indicator lamp) malfunction MIL Circuit Click here
Meter/Gauge system Click here
Engine stalls when starting off Automatic transmission system Click here
Engine stalls Click here
Unable/difficult to refuel Fuel system (canister, roll over valve, fuel tank etc.) -
ECO mode does not change Pattern Select Switch Eco Mode Circuit Click here

HINT:

*: Check the "Fuel Cut Elps Time" in the Data List.

If the elapsed time is over 0 sec, then the engine speed is high (More than the engine speed at which fuel cut occurs + 500 rpm).

When this has happened, there is the possibility that the valve rocker arm will become loose and malfunction, so check that the No. 1 valve rocker arm sub-assembly is properly attached.

Click hereEngine / Hybrid System>2TR-FBE ENGINE MECHANICAL>CAMSHAFT>REMOVAL


Due to the factors listed below, cold engine starting trouble, rough idle, poor drivability, and engine stall may occur:

·

The vehicle is filled with fuel that has an alcohol concentration of 100% (E100).

·

The Data List item "Alcohol Density Learning" on the GTS is "Incmpl" (if "Alcohol Density Learning" is "Incmpl", this means that the alcohol concentration learning has not been completed).

·

"Alcohol Density Learning" does not change to "Incmpl" even though the vehicle is refueled (if the amount refueled is 8 liters or less, or the fuel sender gauge is malfunctioning, "Alcohol Density Learning" may not change to "Incmpl"). The ECM does not perform alcohol concentration learning if "Alcohol Density Learning" does not change to "Incmpl". If alcohol concentration learning is not performed, the ECM cannot command the injectors to inject the appropriate amount of fuel for combustion.