Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING RECEIVER(for Double Cab) › from 2016.08
RM3250E _53 Suspension _057180 TIRE PRESSURE MONITORING _0279607 TIRE PRESSURE WARNING RECEIVER(for Double Cab) A

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING RECEIVER(for Double Cab)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during tire pressure warning receiver removal/installation are shown below.

Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Disconnect cable from negative battery terminal Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) Stop and start system (Click here)
Memorize steering angle neutral point Pre-crash safety system (Click here)
Tire pressure warning ECU and receiver
·

Register transmitter ID

·

Initialize tire pressure warning system


·

When DTC detection conditions of "transmitter ID not received" DTC are met, TPWS indicator blinks for 1 minute, and then illuminates.

·

Tire pressure warning function


for Registration:(Click here)
for Initialization:(Click here)

PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE REAR SEAT ASSEMBLY

Hide 67918E 4.REMOVE REAR DOOR SCUFF PLATE LH

Hide 67917C 5.REMOVE REAR DOOR SCUFF PLATE RH

Hide 62514A 6.REMOVE LOWER QUARTER TRIM PANEL LH

Hide 62513A 7.REMOVE LOWER QUARTER TRIM PANEL RH

Hide 64261C 8.REMOVE UPPER BACK PANEL GARNISH

Hide 73178B 9.REMOVE SEAT BELT ANCHOR COVER CAP

Hide 62512 10.REMOVE QUARTER INSIDE TRIM BOARD LH

Hide 62511 11.REMOVE QUARTER INSIDE TRIM BOARD RH

Hide 64271C 12.REMOVE BACK PANEL TRIM

a.
C354067C01
0.115,0.104 0.427,0.302 0.313,0.198 10 true *A 0.104,2.656 0.417,2.854 0.313,0.198 10 true *B
*A for Type A
*B for Type B


Remove the 5 clips and back panel trim.


Hide 89760C 13.REMOVE TIRE PRESSURE WARNING ECU AND RECEIVER

NOTICE:
·

Do not drop the tire pressure warning ECU and receiver, strike it with tools or subject it to impact.

·

If the tire pressure warning ECU and receiver is subjected to an impact, replace it with a new one.



a.
C354053

Remove the bolt.


b.

Detach the 2 guides to remove the tire pressure warning ECU and receiver.


c.

Disconnect the connector from the tire pressure warning ECU and receiver.