77377
1.INSTALL FUEL FILLER OPENING LID LOCK RETAINER
|
Install in this Direction |
Install a new fuel filler opening lid lock retainer as shown in the illustration.
77035
2.INSTALL FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY (for LHD)
|
Install in this Direction |
Attach the claw to install the fuel lid lock control cable sub-assembly to the fuel filler opening lid lock retainer as shown in the illustration.
Attach the fuel lid lock control cable sub-assembly to each clamp as shown in the illustration.
Install the grommet to the vehicle body.
| *1 | Fuel Lid Lock Control Cable Sub-assembly | *2 | Grommet |
77035
3.INSTALL FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY (for RHD)
|
Install in this Direction |
Attach the claw to install the fuel lid lock control cable sub-assembly to the fuel filler opening lid lock retainer as shown in the illustration.
Attach the fuel lid lock control cable sub-assembly to each clamp as shown in the illustration.
Install the grommet to the vehicle body.
| *A | for 4WD and Pre-Runner without VSC | - | - |
| *1 | Fuel Lid Lock Control Cable Sub-assembly | *2 | Grommet |
77306
4.INSTALL FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY (for LHD)
Attach the claw to install the fuel lid lock open lever sub-assembly.
77306
5.INSTALL FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY (for RHD)
Attach the claw to install the fuel lid lock open lever sub-assembly.
65638
6.INSTALL REAR WHEEL HOUSE LINER LH
Install the rear wheel house liner LH.
58510D
7.INSTALL FRONT FLOOR CARPET ASSEMBLY
Install the front floor carpet assembly.
62514A
8.INSTALL LOWER QUARTER TRIM PANEL LH
62414A
9.INSTALL LOWER CENTER PILLAR GARNISH LH
67918E
10.INSTALL REAR DOOR SCUFF PLATE LH
62112
11.INSTALL COWL SIDE TRIM BOARD LH (for LHD)
62111C
12.INSTALL COWL SIDE TRIM BOARD RH (for RHD)
67914B
13.INSTALL FRONT DOOR SCUFF PLATE LH
67913B
14.INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)
58810J
15.INSTALL CONSOLE BOX ASSEMBLY (for RHD, w/ Console Box Lid)
58901A
16.INSTALL REAR CONSOLE BOX SUB-ASSEMBLY (for RHD, w/ Rear Console Box)
17.INSTALL REAR SEAT ASSEMBLY
for Seat Cushion 60/40 Split Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY(for Seat Cushion 60/40 Split Type)>INSTALLATION
for Seat Cushion Bench Type:
Click hereVehicle Interior>SEAT>REAR SEAT ASSEMBLY(for Seat Cushion Bench Type)>INSTALLATION
18.INSTALL FRONT SEAT ASSEMBLY RH (for RHD)
for Manual Seat:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Manual Seat)>INSTALLATION
for Power Seat:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Power Seat)>INSTALLATION
19.INSTALL FRONT SEAT ASSEMBLY LH
for Manual Seat:
Use the same procedure described for the RH side.
for Power Seat:
Use the same procedure described for the RH side.
for Bench Seat Type:
Click hereVehicle Interior>SEAT>FRONT SEAT ASSEMBLY(for Bench Seat Type)>INSTALLATION