When replacing the parts in the following chart (A), replace the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and/or fuel inlet pipe sub-assembly with new ones.
| Replaced Parts (A) | Pipes Requiring New Replacement |
|---|---|
·
Injector assembly (including shuffling the injector assemblies between the cylinders) ·
Common rail assembly ·
Cylinder head sub-assembly |
·
No. 1 injection pipe sub-assembly ·
No. 2 injection pipe sub-assembly ·
No. 3 injection pipe sub-assembly ·
No. 4 injection pipe sub-assembly |
·
Supply pump assembly ·
Common rail assembly ·
Cylinder block sub-assembly ·
Cylinder head sub-assembly ·
Cylinder head gasket ·
Timing Gear Case Assembly |
Fuel inlet pipe sub-assembly |
After removing the No. 1 injection pipe sub-assembly, No. 2 injection pipe sub-assembly, No. 3 injection pipe sub-assembly, No. 4 injection pipe sub-assembly and fuel inlet pipe sub-assembly, clean them with a brush and compressed air.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
51410
3.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
4.DRAIN ENGINE COOLANT
17113E
5.REMOVE NO. 1 INTAKE PIPE
16571C
6.REMOVE NO. 1 RADIATOR HOSE
44360
7.DISCONNECT VANE PUMP OIL RESERVOIR ASSEMBLY
44369A
8.REMOVE OIL RESERVOIR BRACKET
16470
9.REMOVE RADIATOR RESERVOIR
16711
10.REMOVE FAN SHROUD
88320
11.DISCONNECT COOLER COMPRESSOR ASSEMBLY
12.REMOVE NO. 2 IDLE PULLEY ASSEMBLY
27020
13.REMOVE GENERATOR ASSEMBLY
12511C
14.REMOVE GENERATOR BRACKET
16620
15.REMOVE V-RIBBED BELT TENSIONER ASSEMBLY
23701
16.REMOVE NO. 1, NO. 2 AND NO. 3 INJECTION PIPE SUB-ASSEMBLY
23704
17.REMOVE NO. 4 INJECTION PIPE SUB-ASSEMBLY
11201
18.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY
11322A
19.REMOVE NO. 1 TIMING BELT COVER
13568
20.REMOVE TIMING BELT
13505
21.REMOVE NO. 1 TIMING BELT IDLER SUB-ASSEMBLY
13523
22.REMOVE CAMSHAFT TIMING PULLEY
11322B
23.REMOVE NO. 2 TIMING BELT COVER
16100
24.REMOVE ENGINE WATER PUMP ASSEMBLY
|
Bolt |
|
Nut |
Remove the 5 bolts, 2 nuts, engine water pump assembly and gasket.