Home › Engine / Hybrid System › 2TR-FE ENGINE CONTROL › SFI SYSTEM › from 2016.01
RM3270E _51 Engine / Hybrid System _048938 2TR-FE ENGINE CONTROL _0241353 SFI SYSTEM T

2TR-FE ENGINE CONTROL  SFI SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



SFI System
Symptom Suspected Area Link
Engine does not crank (Does not start) Battery Click here
Starter assembly (for 2.0 kW Type) Click here
Starter assembly (except 2.0 kW Type) Click here
Starter assembly (for BOSCH Made) Click here
Smart entry and start system (for Start function) Click here
Park/neutral position switch assembly (for AC60E) Click here
Park/neutral position switch assembly (for AC60F) Click here
Clutch start switch assembly Click here
VC output circuit (ECM 5 V circuit) Click here
Starter signal circuit Click here
ECM power source circuit Click here
No initial combustion (Does not start) Immobiliser system (w/ Entry and Start System) Click here
Immobiliser system (w/o Entry and Start System) Click here
VC output circuit (ECM 5 V output) Click here
ECM power source circuit Click here
Crankshaft position sensor Click here
Camshaft position sensor (for Intake Side) Click here
Camshaft position sensor (for Exhaust Side) Click here
Valve timing Click here
Ignition system Click here
Fuel pump control circuit Click here
Fuel injector circuit Click here
Starter signal circuit Click here
No. 1 valve rocker arm sub-assembly* -
Engine cranks normally but difficult to start Engine difficult to start Click here
Fuel pump control circuit Click here
Engine coolant temperature sensor Click here
Ignition system Click here
Compression Click here
Fuel injector assembly Click here
Fuel injector circuit Click here
Intake system Click here
Throttle body with motor assembly Click here
PCV valve and hose Click here
Starter signal circuit Click here
ECM power source circuit Click here
No. 1 valve rocker arm sub-assembly* -
Incomplete intermittent combustion occurs (Does not start) Fuel pump control circuit Click here
Fuel pump Click here
Fuel line -
Ignition system Click here
Fuel injector circuit Click here
ECM power source circuit Click here
Starter signal circuit Click here
Crankshaft position sensor Click here
Camshaft position sensor (for Intake Side) Click here
Camshaft position sensor (for Exhaust Side) Click here
Valve timing Click here
High engine speed Throttle body with motor assembly Click here
Intake system Click here
A/C signal circuit (for Automatic Air Conditioning System) Click here
A/C signal circuit (for Manual Air Conditioning System) Click here
ECM power source circuit Click here
Engine coolant temperature sensor Click here
PCV valve and hose Click here
Low engine speed (Poor idle) Throttle body with motor assembly Click here
A/C signal circuit (for Automatic Air Conditioning System) Click here
A/C signal circuit (for Manual Air Conditioning System) Click here
Fuel pump control circuit Click here
Fuel pump Click here
Intake system Click here
PCV valve and hose Click here
Engine stalls on deceleration Flow chart [Engine stalls] Click here
Idle speed (refer to "Low engine speed" symptom) -
Rough idle Rough idling Click here
Compression Click here
Ignition system Click here
Spark plug Click here
Fuel injector circuit Click here
ECM power source circuit Click here
Fuel pump control circuit Click here
Fuel pump Click here
Fuel line -
Throttle body with motor assembly Click here
Intake system Click here
Purge VSV Click here
PCV valve and hose Click here
Air fuel ratio sensor Click here
Heated oxygen sensor Click here
Mass air flow meter sub-assembly Click here
Knock control sensor Click here
External part malfunction (Increase in load: A/C system, etc.) -
No. 1 valve rocker arm sub-assembly* -
Hunting (Poor idle) Electronic throttle control system Click here
Intake system Click here
ECM power source circuit Click here
Hesitation and/or poor acceleration (Poor driveability) Fuel pump control circuit Click here
Spark plug Click here
Ignition system Click here
Fuel injector assembly Click here
Mass air flow meter sub-assembly Click here
Electronic throttle control system Click here
Intake system Click here
Compression Click here
Brake override system Click here
No. 1 valve rocker arm sub-assembly* -
Surging (Poor driveability) Spark plug Click here
Fuel pump control circuit Click here
Ignition system Click here
Fuel injector assembly Click here
Mass air flow meter sub-assembly Click here
Variable Valve Timing (VVT) system Click here
Compression Click here
No. 1 valve rocker arm sub-assembly* -
Engine stalls soon after starting Immobiliser system (w/ Entry and Start System) Click here
Immobiliser system (w/o Entry and Start System) Click here
Fuel pump control circuit Click here
Spark plug Click here
Ignition system Click here
Fuel injector assembly Click here
Variable Valve Timing (VVT) system Click here
Electronic throttle control system Click here
Intake system Click here
PCV valve and hose Click here
Compression Click here
No. 1 valve rocker arm sub-assembly* -
Lack of power Lack of power Click here
Brake override system Click here
Engine stalls only during A/C operation A/C signal circuit (for Automatic Air Conditioning System) Click here
A/C signal circuit (for Manual Air Conditioning System) Click here
ECM Click here
MIL (malfunction indicator lamp) malfunction MIL Circuit Click here
Meter/Gauge system Click here
Engine stalls when starting off Automatic transmission system (for AC60E) Click here
Automatic transmission system (for AC60F) Click here
Engine stalls Click here
Unable/difficult to refuel Fuel system (canister, roll over valve, fuel tank etc.) -

HINT:

Check the "Fuel Cut Elps Time" in the Data List.

If the elapsed time is over 0 sec, then the engine speed is high (More than the engine speed at whichfuel cut occurs + 500 rpm).

When this has happened, there is the possibility that the valve rocker arm will become loose andmalfunction, so check that the No. 1 valve rocker arm sub-assembly is properly attached.

Click hereEngine / Hybrid System>2TR-FE ENGINE MECHANICAL>CAMSHAFT>REMOVAL