Home › Engine / Hybrid System › 2TR-FE FUEL › FUEL PRESSURE REGULATOR
RM1880E _51 Engine / Hybrid System _013211 2TR-FE FUEL _0068476 FUEL PRESSURE REGULATOR A

2TR-FE FUEL  FUEL PRESSURE REGULATOR  REMOVAL  


PROCEDURE

Hide 1.DISCHARGE FUEL SYSTEM PRESSURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 6.REMOVE FUEL PRESSURE REGULATOR ASSEMBLY

a.
A252057

Disconnect the purge VSV connector.


b.

Disconnect the throttle body connector.


c.

Detach the wire harness clamp.


d.
A252048

Disconnect the vacuum hose.


e.

Remove the 3 bolts and fuel pressure regulator.