2013-2015 Land Cruiser Prado · Service Manual Engine / Hybrid System

P0116 Engine Coolant Temperature Circuit Range / Performance

Diagnostic trouble codes · Vehicles built from Aug 2014

Versions by build date: Aug 2013 – Jul 2014 from Aug 2014

DESCRIPTION

Refer to DTC P0115 (Click here).
DTC No.
DTC Detection Condition
Trouble Area
P0116
When the engine is started cold and warmed up, the engine coolant temperature sensor value does not change (2 trip detection logic).
  1. Thermostat
  2. Engine coolant temperature sensor

INSPECTION PROCEDURE

HINT:
  1. If DTC P0115, P0117 or P0118 is output simultaneously with DTC P0116, the engine coolant temperature sensor may have an open or a short circuit. Troubleshoot those DTCs first.
  1. Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.


1. CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0116)
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to ON and turn the tester on.

  1. Enter the following menus: Powertrain / Engine and ECT / DTC.

  1. Read the DTCs.

    Result 
    Result
    Proceed to
    DTC P0116 is output
    A
    DTC P0116 and other DTCs are output
    B

    HINT:
    If any DTCs other than P0116 are output, troubleshoot those DTCs first.



B
GO TO DTC CHART (Click here)
A


2. INSPECT THERMOSTAT
  1. Inspect the thermostat (Click here).



NG
REPLACE THERMOSTAT (Click here)
OK

REPLACE ENGINE COOLANT TEMPERATURE SENSOR (Click here)


← P0116 Engine Coolant Temperature Circuit Range / Performance (Aug 2013 – Jul 2014)P0120 Throttle / Pedal Position Sensor / Switch "A" Circuit (+ 7 more codes) (from Aug 2013) →